- 2” lift
- High beam issue
- Help.... Stall and No Start
- 35s to 33s with AX15
- ARB Bumper Question
- jeep xj truck
- Buying used lifted xj
- Stock vs Moly Dana 30 Axle Shafts?
- Zj fan clutch
- Rear end noise at 50 and above
- Reverse Signal Wire
- Parking Lights, Dash Lights, Instrument Cluster Blowing Fuses Immediately
- I have increased Gas Mileage.
- looking for inner pics of cav fab 3 link cross member
- Considering a Cummins 2.8 repower, a couple of questions
- Cellphone mounts/holders ???
- Is there ANYTHING I can do for squeaky poly bushings?
- Will a JK 44 fit?
- Does anyone on here fabricate a good hitch tire carrier by chance?
- 2001 dual Cat removal?
- Diesel Conversions
- 50 flat light bar
- Another crazy/stupid intake mod idea
- Thoughts on 8.25 upgrades ?
- Crawled under your Jeep lately???
- Relative Front/Rear Suspension Flex (w/ and w/o front anti-sway bar)
- Grinding noise after lift install HELP!!
- Need help with efan override
- Alignment check
- pinion angle and relocation shackles.
- Are my ears a better tachometer?
- Leveling
- Rock Sliders with Long Arm
- Fender flare options
- 31's with 3.73's vs 4.10's tricky situation
- 2x6 air tight rock sliders
- RC 4.5" regular vs. X-series - would I notice?
- 1 ton axle swap help please
- 4.0 to 2.5 swap
- Mopar Sure-Grip Differentials for 8.25
- 231 chain suggestions
- Doorless 97+, What pins to buy?
- Regear from 3.55, new carrier?
- Synthetic Blend High Mileage Oil?
- What upgrades and in what order?
- No gauges
- Oil Cooler - Where to mount?
- Standalone harness
- Axle swap
- Flashing Light/No Power on Hills
- Bushings Poly / Rubber ?
- Drivers seat further back and lower
- leaf spring hardware source
- Wha da hay, no rear brakes
- OX lockers
- My Jeep Likes to Hit it From Behind ft. Mercedes
- NP231 input shaft delema
- Baseball Card When I Sound Right
- steering problems
- 8.25 axle shafts
- Clunking Noise when coming to a complete stop.
- Transmission clunk on downshift while driving in 3rd gear
- Brown dog motor mount rebuild
- cooling system upgrade
- Rustys 2in Full Length Add-A-Leaf
- Where to buy
- Tj d44 axle shafts in a d30
- Question about bumper fitments
- Rubicon Express Control Arm Bushings
- Bumpstop/Shock Length Help
- OME CS033RB cracked plastic side retainers?
- OME CS033RB bushing size?
- Popping/Grindy Noise From Tranny/Tcase? (98 XJ/4.0 5spd/ 218k miles)
- 97-01 FPR Addition Mod
- 89 to 93 Engine Swap
- Issue with front coil spring
- Rumble strip vibrations
- Iron Rock off Road track bar and tie rod RHD
- Bell housing bolts
- Insta Winch
- Cavfab steering
- Wj steering pump
- XJ front drive shaft
- Steering Gear Box
- I Need Some Help Finding Wheels
- 8.8 Question.
- Tire size comparison
- 2000/2001 - 98/99 Ignition Retrofit
- Inner Tie Rods
- Belly skid
- THOR cowl intake
- 1 tpm steering
- 2.5l to 4.0 engine and trans swap
- XJ Drag link setup
- Need advice on some new parts guys.
- Good alarm system thats somewhat budget friendly
- Alternator upgrade?
- Coil spacers effect.
- Grand Cherokee rear end to XJ
- Which wheels? Opinions needed
- Shackle Angle
- Modify tire carrier?
- NP231 Output Flange
- Need help with boot release
- 4.5 inch lift problems
- Need help with finding parts or part numbers.
- diptard needing advice
- 99 front drive shaft bind
- How to fix body damage
- Check engine light on after snorkel install.
- LED Turn Signals - Strange issues
- Oil filter relocation/adapter delete?
- Need help with tie rod and center link ends
- steering and reaming out D30 knuckles(strength?s)
- bastard pack too tall
- Spartan Locker on rear D35 - Daily Driver/Weekend Warrior
- 1998 Cherokee XJ brake booster upgrade?
- 00 XJ with a 94 Toyota Land Cruiser OEM brush guard?
- AXLE SHOP
- 2001 TJ running gear to 1999 XJ
- 99 radiator
- Clicking in Dash While Driving (Pre-97)
- '98 Cherokee Build Advice and Sanity Check
- Horizontal steering wheel adjustment?
- Noise coming from the rear after new lift install
- 99 XY problems.
- Lifted xj vibration issue
- Opinions on two different aftermarket skid plates?
- Upper right Front Control Arm Bushing loose
- C8.25 Detroit Locker availability
- New Build Needs Help
- Cross member thread stripes
- Transfer case question
- alternator
- BPE front body side mounts,photo help please
- Oil Analysis Through Napa
- Aftermarket Cruise Control on a 89' Renix?
- Sway bar drop bracket question
- rugged retrofits
- Sounds like something is loose in the front end...
- Which track bar for me
- Creaking/ Squeaking sound when hitting bumps
- Chrysler 8.25 vs Ford 8.8?
- Losing fuel dramatically fast
- 2.5 TD XJ Axle Swap in 4.0R6 XJ
- At my wits end
- Transfer case chain or linkage needs adjustment?
- Old Man EMU build from Stock
- 97+ Clear marker lenses?
- Longer front brake lines REQUIRED for 3" lift?
- Suspension upgrade
- Thud noise in the back end
- Resistor or not???
- Let's see your custom cubby storage contraptions !!
- XJ Dash-Heater Swap
- Np242 to np231 swap
- 2000 XJ Limited
- Does a sway bar disconnect on a 3" lift make sense?
- Yakima Towers
- bought a 99 Cherokee converted to a manual
- Dana 30
- Bogger cut
- 3.75" back spacing 30 inch tire
- Chopped XJ / Roll Cage Help Needed
- Front winch bumper bolts
- Interior trim panel crossover years? 2 door
- 95 xj tierod
- Skyjacker 6 inch rock ready double flex
- Long arm Vs. Short for drivability.
- What tailpipe?
- Rubicon express 3.5 average lift height? Owners please reply!
- Skid Plate
- steering stabilizer
- Hack and tap with front driveshaft moved to rear?
- For all the people with or without an sye
- Revisiting the injector upgrade conversation.
- 1st XJ, newly lifted and finding some issues. Looking for advice and feedback
- Wheels won't fit after rear disc brake swap
- Which shocks for 3-4” lifted Dd xj?
- Hella Halogen headlights - discontinued?
- Jeep temps drop, then idles around 1000 rpm and is hard to start after
- Bushwacker Flat Fender or Notch Customs X-Max Fender
- ZJ / XJ RKE swap
- Rear hatch aux lighting
- 4.88 In A Chrysler 8.25"?
- Dana 30 breather fitting
- Axle question
- Who makes the strongest LCA's?
- 4.0l to 4.2l intake power steering bracket
- Just why are headers non compliant with emissions?
- Popping/Binding Noise coming from T/C
- Rc, zone, iro for 3” lift 99 xj
- Trac Bar drop bracket
- Lifter question (possible roller lifters)
- Bump Stop Sizing
- Death Wobble Help
- Xj seat swap
- 3 inch zone lift
- 1989 xj help!!
- Pinion angle/drive line question
- Lift upgrade questions
- Tyre carriers on XJs
- RT Off Road Aluminum valve cover
- XJ 242 power ratings.
- removing a trac bar bracket, frame side
- 1 Ton Clearance Issues
- I'm Baaaaccckkkk
- 99 xj lift questions
- Help me find another one of my Cherokee’s
- What differentials do I have?
- Lockers and gears question
- Body armour
- No lift shackle relocation help and opinions.
- OEM headlight socket for H4 harness conversion
- Having Trouble Repurposing Power/Comfort or Fog Light Switch
- temp trash
- Light cubes question
- Front axle with adjustable control arms question
- What kind of lockers shoukd i get
- Air down what psi
- Can I add this to my lift?
- Steel Flare - Deflection Ability
- welded rear axle
- WJ steering pump on Renix.
- Aftermarket ECU options
- Dorman 929-301 vs Crown 4886186AA HD leaf springs for stock XJ?
- 2" Tranfer drop ?
- Anyone want a digital dash ?
- Rustys Sway Bar Discos Install Question
- 2 inch budget lift 2000 xj
- Looking for a lift in NH area used.
- New (to me) 2001 XJ - question on parts
- Upgrading steering, need opinions.
- Bored Renix Throttle body
- Detroit Truetrac for my '98 XJ
- LED fog lights?
- Basic long arm?
- 98' booster to a 90' Xj
- New project
- Headlight Relay wiring
- V8 engine and manual tranny
- Deep water/mud questions...
- Aussie, Spartan, Powertrax no-slip
- Trying to id a lift
- Engine swap on a ‘99 xj
- How big of a lift do i need to fix 33s if i trim the fenders?
- 2 questions regarding a newly purchased xj
- Matching front bolt pattern to Ford 8.8
- 3 inch lift with 1 inch Tcase drop HELP
- Core 4x4 long arm, Trac bar. Anyone running them?