NP231 Output Flange
#1
Senior Member
Thread Starter
Join Date: Dec 2017
Location: Calgary, AB
Posts: 622
Likes: 0
Received 9 Likes
on
7 Posts
Year: 1998
Model: Grand Cherokee (ZJ)
Engine: 5.2
NP231 Output Flange
I'm looking at a really cheap NP231 right now but the guy says its been drilled and tapped for a output flange to use on a Toyota. Has anyone heard of this? Would it be possible to take the flange off and just run the normal driveshaft? Or could I just pop on a front driveshaft and go?
Last edited by firebane; 03-31-2018 at 09:41 AM.
#2
CF Veteran
Join Date: Jun 2016
Location: Santa Clarita California
Posts: 2,138
Likes: 0
Received 277 Likes
on
243 Posts
Year: 2001
Model: Cherokee (XJ)
Engine: 4.0L
Has the shaft been cut short or is it full length , if it is full length you should be able to install the rear drive shaft , if it cut just in stall a front drive shaft and see how that works .
Thread
Thread Starter
Forum
Replies
Last Post
reddheadnla
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
01-23-2012 06:56 PM
gintaras
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
03-02-2010 10:15 AM
yorkite
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
01-22-2010 10:25 PM
Cherokee 4.0
For sale
6
11-18-2009 02:26 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)