I have increased Gas Mileage.
#1
Junior Member
Thread Starter
I have increased Gas Mileage.
I will try to explain this the best I can as i am not a mechanic (but am learning a lot here).
I recently went on a 4K mile road trip. While I was visiting my brother in Denver, I asked him about putting an air dam on my jeep.
I had read about how the engine bay gets air trapped up in there, which causes drag and higher coolant temps.
So - I drew out a cardboard template and my brother went to work. took him about 3 hours and he had all the tools and materials (we were lucky!).
Materials: thin aluminum powder-coated piece, long enough and high enough (the bottom edge of the air dam was 8" from the ground after it was installed); black rivets; a short aluminum L-bracket to give stability to the bottom piece so it doesn't flex in high winds; titanium bolts/nuts to fasten to the existing holes in the "spoiler"; black engine paint to paint the L-bracket; stainless steel (20-gauge) wire that was twisted to attach to the L bracket at the bottom so that the air dam would not be pushed back on the vertical plane at high speeds/winds; black heat shrink for the wire; stainless steel eyelets with locking nuts to attach wire to L-bracket.
Fortunately, the existing spoiler/air-dam on the jeep had vertical brackets underneath (I believe there were 5 of them) so that attaching the new spoiler to it would provide plenty of support, for both increased wind and weight. Black rivets were also used to attach the aluminum to the side of the wheel flairs. The sides were "rounded" by using a small fire extinguisher to roll the ends of the new dam, just enough so those end could be riveted in to the existing flairs. My brother is a race car builder and had all the tools and even had the powder-coated aluminum pieces left over from a previous racing project. Here are some pics.
The results are truly amazing. Before, I was getting about 17 mpg at highway speed. The install was done in Denver. I traveled to Santa Fe, then Austin, then San Antonio, then Phoenix, then back home to S.F. I filled up regularly and calculated my mpg. Average on the trip, going 80 mph on many of those highways, 21 mpg. My best mpg happened from Denver to Santa Fe > rolling hills a plenty. Remember those storms we had in the Midwest around the 12th of April? Thunderstorms in Texas and later, snow in Denver? Well, I was a day or two ahead of those storms, but there was a very strong north to south wind. It was my "tailwind" for that drive from Denver to Santa Fe. It literally pushed me south. MPG = 26 ! That was one time only, with about 180 miles traveled. After that, my mpg varied tremendously from around 20.5 to 23 freeway driving.
Neither my brother or myself expected such results. I kept calling him when I was on the road to report the great gas mileage. There were some other benefits as well. Normally I can feel the drag of front of the truck when there is gusty winds. Not any more. I could hear the wind at the windshield only. next, my water temp was lower, about 1/8" more to the left on the temp gauge, I guess about 10 degrees? Never got to 12 O'clock. Also, you know coming back from Arizona into the 210 at L.A., where there is that 6-mile long uphill mostly grade, before the grapevine? I've made the trip before to see my folks in Austin and always had to stay in the right lane with the trucks (drag and high altitude). This time, I could actually accelerate ! It was amazing to be able to punch it and the truck would kick into a lower gear and take off. Note: I believe that the 1989 ECU/ECM that I put into this '88 truck helped with the increased power too.
I know this sounds unbelievable, but the air dam really worked to keep the drag out of the engine bay, lower the engine temps, and consequently give me better gas mileage. Back in the bay area, I don't get on the freeway much until summer time so am getting pretty much the same 15-16 mpg around town. I want to thank Cruiser54 for his help with all the other mods and his work was an inspiration to me to get this project done.
I recently went on a 4K mile road trip. While I was visiting my brother in Denver, I asked him about putting an air dam on my jeep.
I had read about how the engine bay gets air trapped up in there, which causes drag and higher coolant temps.
So - I drew out a cardboard template and my brother went to work. took him about 3 hours and he had all the tools and materials (we were lucky!).
Materials: thin aluminum powder-coated piece, long enough and high enough (the bottom edge of the air dam was 8" from the ground after it was installed); black rivets; a short aluminum L-bracket to give stability to the bottom piece so it doesn't flex in high winds; titanium bolts/nuts to fasten to the existing holes in the "spoiler"; black engine paint to paint the L-bracket; stainless steel (20-gauge) wire that was twisted to attach to the L bracket at the bottom so that the air dam would not be pushed back on the vertical plane at high speeds/winds; black heat shrink for the wire; stainless steel eyelets with locking nuts to attach wire to L-bracket.
Fortunately, the existing spoiler/air-dam on the jeep had vertical brackets underneath (I believe there were 5 of them) so that attaching the new spoiler to it would provide plenty of support, for both increased wind and weight. Black rivets were also used to attach the aluminum to the side of the wheel flairs. The sides were "rounded" by using a small fire extinguisher to roll the ends of the new dam, just enough so those end could be riveted in to the existing flairs. My brother is a race car builder and had all the tools and even had the powder-coated aluminum pieces left over from a previous racing project. Here are some pics.
The results are truly amazing. Before, I was getting about 17 mpg at highway speed. The install was done in Denver. I traveled to Santa Fe, then Austin, then San Antonio, then Phoenix, then back home to S.F. I filled up regularly and calculated my mpg. Average on the trip, going 80 mph on many of those highways, 21 mpg. My best mpg happened from Denver to Santa Fe > rolling hills a plenty. Remember those storms we had in the Midwest around the 12th of April? Thunderstorms in Texas and later, snow in Denver? Well, I was a day or two ahead of those storms, but there was a very strong north to south wind. It was my "tailwind" for that drive from Denver to Santa Fe. It literally pushed me south. MPG = 26 ! That was one time only, with about 180 miles traveled. After that, my mpg varied tremendously from around 20.5 to 23 freeway driving.
Neither my brother or myself expected such results. I kept calling him when I was on the road to report the great gas mileage. There were some other benefits as well. Normally I can feel the drag of front of the truck when there is gusty winds. Not any more. I could hear the wind at the windshield only. next, my water temp was lower, about 1/8" more to the left on the temp gauge, I guess about 10 degrees? Never got to 12 O'clock. Also, you know coming back from Arizona into the 210 at L.A., where there is that 6-mile long uphill mostly grade, before the grapevine? I've made the trip before to see my folks in Austin and always had to stay in the right lane with the trucks (drag and high altitude). This time, I could actually accelerate ! It was amazing to be able to punch it and the truck would kick into a lower gear and take off. Note: I believe that the 1989 ECU/ECM that I put into this '88 truck helped with the increased power too.
I know this sounds unbelievable, but the air dam really worked to keep the drag out of the engine bay, lower the engine temps, and consequently give me better gas mileage. Back in the bay area, I don't get on the freeway much until summer time so am getting pretty much the same 15-16 mpg around town. I want to thank Cruiser54 for his help with all the other mods and his work was an inspiration to me to get this project done.
#2
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,872
Received 1,526 Likes
on
1,238 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
Very interesting.
#3
CF Veteran
Join Date: May 2015
Location: Arizona
Posts: 4,481
Likes: 0
Received 16 Likes
on
12 Posts
Year: 97
Model: Cherokee
Engine: 4.0
The physics makes sense and of course it works. I think this is not done more because of the off road clearance factor. Maybe a quick fastener removable dam maybe?
#4
Beach Bum
Nice modification. I understand this is the sole reason for the factory air dam on a number of Jeep models, fuel efficiency.
#5
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,872
Received 1,526 Likes
on
1,238 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
I had a spring loaded one on my VW Bug.
At 35 MPH, it came down into place. Was more for keeping the front end planted at high speed than anything else. Worked well.
I've done the vertical "air dam" on a Datsun 2000 and a Datsun Z, which is not unlike what's been done on this Jeep, with excellent results in high speed handling. Never cared about fuel mileage.
At 35 MPH, it came down into place. Was more for keeping the front end planted at high speed than anything else. Worked well.
I've done the vertical "air dam" on a Datsun 2000 and a Datsun Z, which is not unlike what's been done on this Jeep, with excellent results in high speed handling. Never cared about fuel mileage.
#6
CF Veteran
Join Date: May 2015
Location: Arizona
Posts: 4,481
Likes: 0
Received 16 Likes
on
12 Posts
Year: 97
Model: Cherokee
Engine: 4.0
I had a spring loaded one on my VW Bug.
At 35 MPH, it came down into place. Was more for keeping the front end planted at high speed than anything else. Worked well.
I've done the vertical "air dam" on a Datsun 2000 and a Datsun Z, which is not unlike what's been done on this Jeep, with excellent results in high speed handling. Never cared about fuel mileage.
At 35 MPH, it came down into place. Was more for keeping the front end planted at high speed than anything else. Worked well.
I've done the vertical "air dam" on a Datsun 2000 and a Datsun Z, which is not unlike what's been done on this Jeep, with excellent results in high speed handling. Never cared about fuel mileage.
Trending Topics
#8
CF Veteran
Join Date: Oct 2013
Location: Tarpon Springs, FL / Denver, CO
Posts: 2,097
Likes: 0
Received 8 Likes
on
7 Posts
Year: '98
Engine: 4.0 I6
I mean, 80mph on the highway is pretty reasonable unless you have all the time in the world. I think going from 18 to ~25mpg is a pretty significant improvement considering the speed/drag
Want to save even more fuel? Walk, or push your XJ
OP, you might be able to eek a bit more efficiency by damming up the radiator a little (not completely of course)
Want to save even more fuel? Walk, or push your XJ
OP, you might be able to eek a bit more efficiency by damming up the radiator a little (not completely of course)
#9
CF Veteran
Join Date: Feb 2016
Location: Northern New Mexico
Posts: 3,683
Likes: 0
Received 7 Likes
on
6 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
I mean, 80mph on the highway is pretty reasonable unless you have all the time in the world. I think going from 18 to ~25mpg is a pretty significant improvement considering the speed/drag
Want to save even more fuel? Walk, or push your XJ
OP, you might be able to eek a bit more efficiency by damming up the radiator a little (not completely of course)
Want to save even more fuel? Walk, or push your XJ
OP, you might be able to eek a bit more efficiency by damming up the radiator a little (not completely of course)
#10
CF Veteran
Join Date: Feb 2012
Location: central IN
Posts: 2,282
Likes: 0
Received 15 Likes
on
11 Posts
Year: 1997
Engine: 4.0
vw bug...high speed...when did 5-speed commandeer your account? ive often considered a modification like this as my xj is strictly a pavement queen. end result is me not really giving af about fuel mileage. it has piqued my interest as my xj already gets 21+ mpg on the highway.
#11
CF Veteran
vw bug...high speed...when did 5-speed commandeer your account? ive often considered a modification like this as my xj is strictly a pavement queen. end result is me not really giving af about fuel mileage. it has piqued my interest as my xj already gets 21+ mpg on the highway.
#12
CF Veteran
Join Date: Jan 2016
Location: Newport News, VA
Posts: 1,242
Likes: 0
Received 38 Likes
on
37 Posts
Year: 96 & 88 4 dr Cherokees
vw bug...high speed...when did 5-speed commandeer your account? ive often considered a modification like this as my xj is strictly a pavement queen. end result is me not really giving af about fuel mileage. it has piqued my interest as my xj already gets 21+ mpg on the highway.
I ask, cuz I thought my 96 was getting 22 mpg or so, till I checked the speedo against GPS.
Turns out my jeep was, from the factory, off so much on the high side that after I put 31" tires on it, it is only off by 1 mph @ 60.
#13
CF Veteran
Join Date: Feb 2012
Location: central IN
Posts: 2,282
Likes: 0
Received 15 Likes
on
11 Posts
Year: 1997
Engine: 4.0
Have you checked that manually ?? IE, odometer against GPS ??
I ask, cuz I thought my 96 was getting 22 mpg or so, till I checked the speedo against GPS.
Turns out my jeep was, from the factory, off so much on the high side that after I put 31" tires on it, it is only off by 1 mph @ 60.
I ask, cuz I thought my 96 was getting 22 mpg or so, till I checked the speedo against GPS.
Turns out my jeep was, from the factory, off so much on the high side that after I put 31" tires on it, it is only off by 1 mph @ 60.
#14
CF Veteran
I tow my XJ & guarantee you it does NOT save fuel.
#15
CF Veteran
Join Date: Feb 2016
Location: Northern New Mexico
Posts: 3,683
Likes: 0
Received 7 Likes
on
6 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
where you from? I agree with mr waffles. 80 mph is common ground in my state. Lots of big long sections of Highway/interstate that 80 is the norm even though speed limit signs are 75...its that "token" 5 mph over the posted limit these folks reference lol