What is the question? Are they sticking? Etc...

 

I have an 89 cherokee xj limited 4.0. when i start it, the starter keeps running and wont shut off. even when i shut the engine off the starter still runs and tries to turn the engine over.. any ideas?? thanks

 

Starter solenoid ha s done that to me before. Take it off and have it tested.

 

Now that i look at it closer, when the line is spooled out, it would be about even. Allow for mostly up-travel to an anchor point when stuck, its prob about right.

 

Cool

 

PICTURE REQUEST: can someone take a picture of the wires leading to the blower motor resistor? My plug connector melted a long time ago and I cut it off. Now I just have the wires hanging there with a new resistor. My blower motor only works in high. Can I solder these wires to the metal prongs on the resistor?

 

Just replaced the upper and lower ball joints in my 99xj. One of the uppers refuses to seat all the way down. Anyone else ever have this problem?

 

I'll throw all of my questions out there. 1993 cherokee sport, it's not in horrible shape but could be better as most jeeps. First, I know my NSS is shot and I have a new one to put in, could that also have caused my reverse lights not to work; if not, what else could cause that? The bulbs are fine and the break and turn signal lights work, just not reverse. Also, my whole passenger side of power options do not work. I'm not into electrical at all, so what should I look at? The po had screwed around heavily with the rear passenger window, so I put a "new" motor and track in. I can run power right to the motor and it works, but it does not work with switches. Thanks for any answers ahead of time!

 

The answer your first question yes a bad NsS will cause rev lights not to work

 

I have an 89 cherokee xj limited 4.0. when i start it, the starter keeps running and wont shut off. even when i shut the engine off the starter still runs and tries to turn the engine over. i replaced the ignition switch and had the starter/ solenoid tested and its fine. any ideas?? thanks

 

Can someone help me identify this rear axle please? I'm thinking it is the D35, but wanted to be sure. Jeep is a 99 Cherokee 2WD. I have looked at the other threads, but it looks similar to two that are shown. Yes I am completely new to Jeeps. Do the numbers stamped on it tell which it is? here is what is stamped on mine:

Dana
43225
280 8
Peak
02 27 97

 

That's a Dana 35.

 

Ok im installing new coils this weekend .im doing it in my drive way but I need some tips on :how I should support the body and what places to support it at ? I go 1 floor jack 2 jack stands and 1 high lift jack

 

Thanks Skyline!

 

I have an 89 cherokee xj limited 4.0. when i start it, the starter keeps running and wont shut off. even when i shut the engine off the starter still runs and tries to turn the engine over. i replaced the ignition switch and had the starter/ solenoid tested and its fine. any ideas?? thanks