I quickly disconnected mine when I got it and hung it up on a shelf

 

How am I going to fit a shelf under there??

 

I have ZJ seats in my XJ and I ran a fused hot wire from the battery to each seat. That way I can adjust the seat to fit behind the steering wheel before I put the key in (my girlfriend is pretty short and puts the seat like all the war forward). I want to say I have a 25 amp fuse for each of mine though. I blew a 20 when moving a couple of the motors at once one day so I bumped it up and haven't had an issue since then. I have heated leather but don't have the heating elements hooked up.

 

good to know, I ended up doing the exact same thing but I used a 20 amp fuse. I finished the passenger side and I got to finish the driver side tomorrow. Passenger works perfect and is all wired up.

 

No. I can try to get one of the xj doing it. It happens between 40 and 50mph idling downhill.

 

Yup, the whole back flange is broken off. I was so careful. Thinking maybe the PO cracked it and when I removed the manifold the little piece dropped to the ground. Thanks for the photo.

I have a new manifold ordered.

RSWiser

 

Captured nut on front skid. Check for tire clearance.

 

Get some $3 Velcro tie straps and keep them in your glovebox

 

That would work too. I have found that the swaybar will stay where put if the bushings are in good order, just push it up out of the way and strap links to bar.

 

Thanks

 

Got my lights and installed them as well as finished my ZJ seat swap.

 

I almost bought a Chrysler 8.25 axel to replace my Dana 35 but then it occured to me that it looks like I will loose my ABS. Is that right? Can ABS be transfered with the 8.25?

 

no. U ll lose the ABS. Why would u want to keep it? I'm curious

 

I think u posted this in wrong thread lol

 

I ment to post it in the "what did you do to your Cherokee today" thread lol