Where does the vacuum collector connect? Took the bumper off, dont know where it goes

 

There should be a tube coming down from near the battery

 

Im looking for the connection from the collector to the....?

 

What is a vacuum collector? You mean the reservoir? The tube for it runs along the passenger fender and firewall. There's a T at the cruise servo.

 

I just relocated mine to under the coolant pressure bottle. I had several cracks along the old line set path. Its also a good idea to do if you plan on running an aftermarket bumper. I have the larger vacuum canister, it fits, but its tight.

 

Hear is a question for any gear head on here, How many and what are the part numbers for the front suspension control arms, track bars of a '90 Cherokee, 4.0 4WD. Seemsd like nobody but Quadratec list a whole set, salty but it's a whole set, don't realy need the rear spring one yet but sure could use the front set. It creaks and pops almost as bad as me when I get up from a chair. LOL

 

Just did a coolant flush/fill and now my temp reads/maintains 260°???? What did i do wrong?? Is it me or a bad sending unit?

 

Check the temp with a scanner. If that checks Out then I ll try to burp it before checking thermostat

 

Question for anybody that changed the bushing in the front end of a Cherokee. Haw many of the same bushing do I need to do the front end, control arms and track bars??

Double post!!!!!

 

Is it possible to not put in enough coolant? I've had it sitting for the past 15 minutes off and the overflow tank is empty and i put in some more coolant in these last couple minutes

 

Yes it's quite possible.

 

I filled radiator (what appeared to be) full and put some into overflow tank. Ran for a couple minutes temp went up and overflow stayed at same level until it sat off for 15 minutes and cooled down. I'm slowly working more coolant into the radiator right now

 

Squeeze the top radiator hose as u fill up, it should help purge the air out. Then have engine running with cap off and wait for bubbles to stop coming out then cap it

 

Done. Thanks for the help man, much appreciated!

 

this link will bring you to the page that sells control arms, both upper and lower with bushings: http://www.quadratec.com/category/Je.../121/index.htm Front Upper #56015.005, Front Lower #56015.001

this link will bring you to the track bar that fits your rig. in the picture it has a bushing and TRE so i believe its good to go: http://www.quadratec.com/products/918205_03.htm #918205.03

curious about a couple things, though. what whole set do you refer to and can you clarify what you mean by "the rear spring one".