Go watch the blind date video!!

 

Those guys are nuts.

 

Alright guys, every time it rains or I go mudding I always get two little puddles of water in each little section under my rear seat where I keep my strap and misc recovery gear. I know where it's coming from now! Where the seat pivots on the mount for the lower part of the seat bottom, the mounts tore away from the inner fender a bit. I know I can seal it with some rtv but I need something sturdier. I haul about 900 lbs of fish food in my jeep once a week for my job. I fold the seat down and just stack it up in the cargo area. So there's usually about 400 lbs of food just on that section of the seat that's folded down. So I think that's why it's starting to tear away from the inner fender well. What do y'all suggest as a fix to this?
Thanks guys

 

Heavy sheet metal

 

Okidoki. I got the plugs replaced. Ended up having to get Bosch. I replaced the cables, rotor and cap as well. Had to go with Duralast. Again thanks. If I get more time during the week I will get after the O2 sensor.

 

Welded like a patch over the part where it's tearing on the inner wheel well?

 

Are pacesetter headers any good?

 

You get what ya pay for when buying a header. I went with a banks revolver header.

 

Anything to know about replacing the rear driver side door? 4 DR 99 XJ. Got a rust patch and wondering if I can find replacements. Might just buff it off though.

 

I never heard of that one. Is it good

 

Yeup. I'd plate around the area too to prevent it from happening again. Like a larger patch.

 

http://www.bankspower.com/fridaynigh...evolver-header

Check it out here. I love it. Big noticeable difference.

 

Nice! How much did it cost for ya

 

Got mine for $275 nib on Craigslist.

 

Dang if it cost that much on craigslist. I can't imagine how much it cost retail lol