Its not that

 

How do you know?

 

Replaced it

 

Yeah i got a new track bar, but the bar coming from the pitman arm is angle a lot and it is not same as the track bar

 

I think its a fuse but have yet to figure out where it is. Got a Haynes and Chilton in front of me now. Jeeps wiring is in good shape gonna try a hot lead next just to try to get it to run

 

Adjusted?

 

Put a test light on the solenoid wire going into the starter and have someone turn it over. If your not getting any power there check your starter relay and ign switch

 

No fuse in the starter circuit.

 

Anybody

 

Kind of a vauge post. Maybe you should elaborate.

 

2000 xj

Do I need to recharge my ac refrigerant? It's intermittently blowing cold air. At first when I turn on the ac it blows frosty cold air, then after a few minutes it's like the compressor isn't working. I'll turn off the ac for about 5 minutes and when I turn it back on the ac blows cold like normal with no problems.

 

I've got bad UCA and LCA bushings. The arms themselves look fine it's just the bushings. My question is, would it be smarter to buy all new arms or just bushings?

 

Kinda spacy post dude. What are you trying to do? Have you ever clicked on the "pink link" in my signature and done any of the ground improvements?

 

I have a 1991 Cherokee Limited with the fancy interior including the overhead console with temp/compass. When I bought the truck years ago, I knew then the outside temp gauge sensor did not work (mounted behind the front license plate) as the gauge always read 5degrees Celsius. The compass worked fine though. Recently the overhead display went blank altogether. Very recently it has started flashing on and off usually lighting all segments of the LED. Anybody got an idea where I should start????

 

Sounds like bad wiring. Trace them and check for bare spots. Also clean the ground.