Is that 2" or 3"? Looks like 2" needs to be 3" or more.

 

Its a spectre intake tube. Its 3" circumference.

 

Tools are an investment.

 

Sure wish my dad was a car guy at times like these... my almost 18 year old mind just wants to spend money on fun things, not "dumb old tools"! Haha. Thanks again sir.

 

Wait until you get older - tools ARE fun things!

 

I have about $15k in tools.
And just dropped $2k on a new snapon cart that is being made. Lol

This month wait is killing me. But getting a huge flat black full drawer cart.

 

Let's do toolbox pics!!!

 

This cart. But flat black.....should I do pinstripes?

 

I didn't ask about those.

Question: Downpipes
If I replace my factory manifold ('88 Renix), is there a pre-bent downpipe I can buy? Either way, is there a way to get clearance between the downpipe and driveshaft? My u-joints are rubbing it.

 

Replace with REnix manifold or HO manifold? Yes, you can get clearance for sure if you have one made.

 

Definitely. That's one heck of a "cart".

 

Planning on Renix manifold, initially. Need to research. I don't have a local shop that can mandrel bend, and that's why I'm asking if there are pre-bent pipes I can buy somewhere. The clearance question was more to see if anything can be adjusted. It's likely due to my sagged out springs.

 

There we go. This is the same size as im getting. Pinstripes?

 

My electric fan is bad, is there any better direct swaps, and is there one year Cherokee that had a better fan or are they all the same? I'm a 99 4.0 Cherokee

 

There was a change to the angle of the fan blades, but I don't recall the year. Have you hooked it up straight to battery? It's common for the controller to fail, leaving the fan dead. I bypassed the controller and ran mine to a switch in the cab.