Moderator of Jeeps
Quote:
...What is and isn't it doing?Originally Posted by ccooper1234
Why won't it start I tested the fuel pressure and its good. But the battery gauge says 11 volts
CF Veteran
Quote:
...What is and isn't it doing?
I turned the key and I can hear the started but it won't start. What voltage is needed to start. I ran out of gas. Then AAA put 3 gallons in and won't startOriginally Posted by NewKindOfClown
...What is and isn't it doing?
Junior Member
Quote:
I'll give ya 500 bucks for it. As is.Originally Posted by ccooper1234
Why won't it start I tested the fuel pressure and its good. But the battery gauge says 11 volts
Junior Member
Quote:
A steady 12 volts will start the engine. Put a volt meter on the battery while someone tries to start it. If the voltage drops below 10ish while starting your battery is shot.Originally Posted by ccooper1234
I turned the keep and I can hear the started but it won't start. What voltage is needed to start
If it doesn't drop your problem is somewhere else.
CF Veteran
Quote:
I'll give ya 500 bucks for it. As is.
No its fine its probably a bad batteryOriginally Posted by Lowrange2
I'll give ya 500 bucks for it. As is.
Junior Member
Quote:
ill give him $501Originally Posted by Lowrange2
I'll give ya 500 bucks for it. As is.
CF Veteran
OK tried to start it and put a meter on it and it dropped down to 10.8 then went up to 11.5. I love optima batterys 
Moderator of Jeeps
Quote:
Never had a problem with mine. You getting spark?Originally Posted by ccooper1234
OK tried to start it and put a meter on it and it dropped down to 10.8 then went up to 11.5. I love optima batterys
CF Veteran
Quote:
Never had a problem with mine. You getting spark?
Not sure, how do I test? It sounded like it wanted to start but it didn't. I'm kinda hoping its a bad batter so I can get a yellow topOriginally Posted by NewKindOfClown
Never had a problem with mine. You getting spark?
CF Veteran
OK it threw these codes, what's wrong
CF Veteran
P0320 No RPM Signal to PCM. Crankshaft Position Sensor Signal to JTEC. A CKP signal has not been detected at the PCM.
Sounds like a CPS problem.
Sounds like a CPS problem.
Quote:
You ran out of gas... air in the lines.Originally Posted by ccooper1234
Not sure, how do I test? It sounded like it wanted to start but it didn't. I'm kinda hoping its a bad batter so I can get a yellow top
Member
Quote:
Runs on gas not hope lol...I need to find spot for mineOriginally Posted by ccooper1234
Best gas can to mount in cargo area, ran out of gas on a backroad and don't want this to happen again. Waiting on AAA
CF Veteran
Quote:
Sounds like a CPS problem.
Funny thing is that I had already replaced the cpsOriginally Posted by DieselD
P0320 No RPM Signal to PCM. Crankshaft Position Sensor Signal to JTEC. A CKP signal has not been detected at the PCM.Sounds like a CPS problem.
CF Veteran
Quote:
Funny thing is that I had already replaced the cps
Are you still stuck on the side of the road?Originally Posted by ccooper1234
Funny thing is that I had already replaced the cps