98s don't use oil pans...

 

Good I'm not running one either.. stupid oil espolded me piston!

 

Where can I get a decent transmission mount for my 2000 Cherokee? I work for a shop and none of our suppliers can get it so I called the dealer and they said $150!!! I've seen kits on eBay with engine and trans mount for $40 but I'm assuming that's complete junk and I'd be better of with my torn mount.

 

I used one from Advance in my MJ. Probably not the same P/N, but they may have one for you.

 

Ok jeep Cherokee gurus I need your help in a bad way. My 1993 cherokee started running bad a week ago cant figure it out please HELP!!!!! First off it skips stumbles and has gas smell from tailpipe. Ive done plugs wires cap rotor checked timing changed coil changed intake gaskets new tps checked for vac leaks cant find whats going on. i can unplug injector #2 and #3 no change in running changed those for 2 i had in my tool box no change in jeep i am stumped help thanks in advance.

 

Have you tried to pull any codes, not with meter. With the key method

 

I'm looking to install my led lightbar finally. The connector that comes on these lightbars, what can I buy that matches up to it for a quick connect for future removal.

 

yes no real code another tried every thing i can think of with out just throwing parts at it like i said im stumped

 

I know other people will chime in. I can't think straight right now I'm drunk. Butttttttt . Flash the system to start by grounding the positive terminal for 30 secs. There's a chance you need o2 sensors and its causing the system I run rich

 

Got a question about a friends 98 wrangler, I6, ax15 and Dana 35. Recently there's been a pretty bad whine from the rear that only happens with throttle. Usually only after 2nd gear. I opened up the diff and the fluid was grey and clumpy. No metal shavings and the gears looked for the most part fine.

I'm either suspecting ring and pinion or carrier bearings. What do you guys think?

 

Thanks! Picked one up any way so just incase i have it

 

Lifted? Pinion bearing sounds right

 

Stock with the stock 30x9.50x15 tires

 

Any play in the pinion if you pull the shaft?

 

None forward and back, a little up and down and the normal slight twist.