i had the page that had the dimensions for the fromt bumper tie in's but i cant find anyone want to give me a hand and post them on here i would really appreciate it

i think this is what your talking about.. I saved the picture cause I knew it would come in handy when I go to make my front bumper.

I never check if the measurements were right. I took a quick look and it seems to match up.

Thanks man that is actually the link I saw befor and I couldn't find. It again and all good if it doesn't line up exact a lil fabrication can't hurt

http://www.twisted-halo.com/digicam/...er%20mount.pdf
Is this whatyou where lookin for?

Yea that link also helps me out thanks

I totally saved that pic and link. Thanks

X2!

That link was a BIG help!

I know this is a little lazy on my part, but I have a few questions about this:
1. what are the hole sizes?
2. What is the length of the bottom edge?
3. Are the plates the same on both frame rails?
4. Do you sandwich both frame rails meaning do you need four of these plates?
I'm about to get some of these laser cut out of 3/16 CRS but I'm trying to get a few more details without having to take the front of my jeep apart until I'm ready to install. I'll probably plot one out at work and check the paper template against my Jeep. Here's an actual dwg I made off of that PDF but like I said, I'm not sure about a couple of things. I'll update this if I find out it needs to be tweaked.