bumper tie in plate dimensions
#1
Newbie
Thread Starter
Join Date: Jan 2010
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
bumper tie in plate dimensions
i had the page that had the dimensions for the fromt bumper tie in's but i cant find anyone want to give me a hand and post them on here i would really appreciate it
#2
Senior Member
Join Date: Apr 2009
Location: Ontario
Posts: 522
Likes: 0
Received 0 Likes
on
0 Posts
Year: 98' and 99'
Model: Cherokee
Engine: 4.0
i think this is what your talking about.. I saved the picture cause I knew it would come in handy when I go to make my front bumper.
#5
bumper brakets
http://www.twisted-halo.com/digicam/...er%20mount.pdf
Is this whatyou where lookin for?
Is this whatyou where lookin for?
Trending Topics
#9
Senior Member
Join Date: Jan 2010
Location: South Louisiana
Posts: 846
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
Originally Posted by cory
http://www.twisted-halo.com/digicam/...er%20mount.pdf
Is this whatyou where lookin for?
Is this whatyou where lookin for?
#10
Member
I know this is a little lazy on my part, but I have a few questions about this:
1. what are the hole sizes?
2. What is the length of the bottom edge?
3. Are the plates the same on both frame rails?
4. Do you sandwich both frame rails meaning do you need four of these plates?
I'm about to get some of these laser cut out of 3/16 CRS but I'm trying to get a few more details without having to take the front of my jeep apart until I'm ready to install. I'll probably plot one out at work and check the paper template against my Jeep. Here's an actual dwg I made off of that PDF but like I said, I'm not sure about a couple of things. I'll update this if I find out it needs to be tweaked.
1. what are the hole sizes?
2. What is the length of the bottom edge?
3. Are the plates the same on both frame rails?
4. Do you sandwich both frame rails meaning do you need four of these plates?
I'm about to get some of these laser cut out of 3/16 CRS but I'm trying to get a few more details without having to take the front of my jeep apart until I'm ready to install. I'll probably plot one out at work and check the paper template against my Jeep. Here's an actual dwg I made off of that PDF but like I said, I'm not sure about a couple of things. I'll update this if I find out it needs to be tweaked.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)