Thanks for the check. I went to quite a few places but found one at napa. The leafs are ready to go in tomorrow!!

But now I'm still stuck on one of my shock bolts. it is spinning in the frame. Pretty sure the bolt and nut are just corroded and aren't breaking free. I hit it with map gas and was able to sneak a 17mm wrench in to maybe grab hold of the nut in there. Still no luck. So I'm going to try and sneak in there and cut it out in the morning.

If I can't get it, how bad will it be if I drive to a auto place maybe a mile from me to have them get it out? Think she will be fine?

 

Cut The shock bolt off from the outside and punch it thru.

 

That's what I wAs planning on doing. I picked up a few cutting tools from menards last night. Bout to whip me up some breakfast and going to go out there and give it hell!

 

What diameter is the tubing on our sway bars? Looking for new sway bar bushings and NAPA has like three different listings for 26mm 28mm 31mm, thanks in advance

 

Does anybody have a wiring diagram for the radio to mate with a Sony radio bc the po hacked it all up and there's no connectors

 

you have to measure - no way around it

 

Seems like I googled it when I did my radio swap a few years back I had the same po wiring. Lol

 

OK thanks

 

I wasn't tryin to be a d, just meant I think I found a good diagram on a jeep site somewhere thru google but I guess I didn't save it. My bad. Lol

 

Its okay I thought you were trying but I just let it go lol

 

Dang, alright, I tried with a dial caliper, but its in inches, Gotta convert...

 

I tried to find it again but no luck. Seems like it was some site ran by an old dude. Like Steve's jeep site or something. Is there an area on here we could upload diagrams we find so everyone can use em?

 

X 25.4 for mm

 

So I have had this chirp for a while now so I did the sensible thing and threw a bunch of parts at it to see if it would fix it, (AC Bypass, Idler and a new belt) it didn't. So I was down at pepboys picking something up and had them do some kind of ac system check or other for $20, where they diagnose where the noise is coming from. So an hour later they "think" it's the water pump bearing going out. I have the belt off now trying to figure it out for my self now. How freely should the water pump spin by hand? Does it normally make any noise spinning it by hand? I have a stethoscope, but it hasn't helped me much. Thank for the help.

 

Does the chirp get louder and faster when you give her gas. Try to see if it's wobbly