Upgrading to 33" Baja claws soon

 

I got to get tires. Do you guys just go to discount or some other shop or on line?

 

Ia m trying to figure exactly what I have to do to git 31's on to my jeep.
If I need to trim where is trim usually from? I am searching but I can not find it?

 

I may just stuff 31's and hope it works

 

I am going to change my main rear seal Monday. I need the main seal and a pan gasket what else do I need?

 

A friend, 2 bandaids and bunch of shop rags.


I've been missing your posts.


You can get a set of 31" treadwrights for right at 500 bucks shipped.

 

I have to be real careful about cutting my fingers blood thinner makes me bleed. I got all the stuff just need the rear seal and pan gasket I guess. locktite something everyone says.

As to the 31's for daily driving will they fit?

once I get rear seal done I am going to replace water pump and then tires. I will check out treadwright

 

Your Jeep is lifted, right?

If it's not lifted the largest tire you're going to fit on there comfortably is a 235/75r15.

 

265/75-15 549$ delivered

Then I got to get them balanced

Reading on here the 265 fit just a little better
any opinions?

 

Depends on if it's lifted or not...

 

I asume everyone reads all my post and remembers every single thing I say...
My bad.
I have a 2" lift.

 

That's right.

You should be able to for the 265/75s well with a tiny amount of trimming.

 

i just put a 3" lift on my XJ got 235s on it and it really looks funny i'm planing on going with the 31x10s but would like 33s or 35s if they would fix

 

Lowrange2.
I finally got my jeep up and I got under it to look. I am not as sure it is rear main seal. It seems it might be the back part of the valve cover. I was wondering how to tell and if changing the valve cover gasket was easier than changing the main rear seal?

 

valve cover is much easier than the rear main