Yes, but you will have to trim a decent amount

 

Look at Treadwrights.

 

Depends on what you consider "a lot".

 

X2 I just bought a set. It was $560 shipped to my door

 

No such luck s3eing they do not make 33x12.5r15

 

How much trimming will I have to do? Probably isn't a big deal just wanna know if It can be done and still be able to flex and turn

 

Flex, not as much. I prefer down travel and a low center of gravity, so I'm planning to do 35s stock. I'm considering a 3" lift max because of my long wheelbase and horrible break over and departure angles.

Without lifting, a 35 will barely fit in the front wheel well where the unibody rail is. Adjust for your lift height, and you can see how much you would need to trim. In the rear, you're looking at at least a standard cut&fold job. I have a more intense plan for the Comanche.

 

X2, my fenders are not trimmed as high as most people's, and I know I could put 35s on the back with one more inch of bumps top, and I might have to trim another half inch off the front and run another inch if bump. 4 inches of lift and 35s IMHO is the perfect stance.

 

At this point, the real reason I want to do 35s without lifting is cause people keep saying I can't. It isn't practical, but it would work with .5" of up travel lol

 

35s will fit with no lift.

Here is mine..35s on 3 inches

 

I know they will. This is 33s, riding on stock bumpstops, with minimal trimming:

 

Just put air bumps on it, it'll ride fine. Lol

 

No

 

Yes you can.

 

I think I'll just go 33s