ok, i would like to lift the front of the cherokee i'm getting 3" and would like to do it for virtually free.....

is there a reason that i could not build a weld in spacer? basically a tube that slides over the bumpstop tube or whatever you want to call it and have a lip on it 3" lower than stock....

did that make any sense? it would be welded in, so no chance of it sliding out.

 

um probly not a good idea to weld anythng to the coil springs

 

no, not the springs, the "body"......where the bumpstop is...

i'm not THAT dumb

 

so just a 3 inch spring spacer but metal?

 

i guess, only metal and free.....

i'm never seen a 3" poly spacer, i'm also new to this.

would the center tube need to be extended to keep the springs from coming out when the axle droops?

 

sorry haha, dont weld on the unibody either...not a good idea as well

 

Cherokee bodies are pretty strong but kinda thin metal. Welding stuff to the body could end up hurting more then helping...

 

Just fab up a metal spacer. Don't weld it in but slide it in so it can be removed. HowlerGT makes them as well. Maybe you could contact him for some input on a design.

 

will it "clank" around?

i guess i could silicone it to keep it in place

 

put some of the stock little isolators in between the whole set up

 

oops

 

ebay has 3in coil spacers,i bought a 2in for $37 shipped and love it

 

Sounds like a plan. I like the idea OKC.

But the "phone" hasn't rung yet.

 

ive seen a couple 3 inch polys, from where idk

 

springs coming out during flex dont hurt no one