Few years ago I bought a Box 1 3/8 12point socket for install cam seal on a mazda protege engine. But few years after need to repair my Cherokee and found that box have multiple use for it.

First of all, ideal for removing axle nut of the front axle dana 30



Near that you can used it liek a seal driver for the axle seal of the dana 30




And finally he save my life recently. Repairing may rear axle chrysler8.25. the need to adjust bearing preload and backlash. Juste need to take out the front axle nut. take tie zip. bent the tie zip and push the box just 1/2 in socket.cut the exceed tie zip, then you have the perfect tool to reach the adjusting ring of the diff.




Hope this will help other people because I have done lot of search when I try to adjust my diff and some forum were telling they weld old axle nut to extend bar. But not every body have welder machine like me and I can reuse the front axle nut and the box and the extend bar.

 

Very cool. There's a tool thread in Off-Topic sub forum. Could you share that again in there?