Originally Posted by mitchlikesbikes

this thread needs moar cupholders haha

Originally Posted by jeeperscreepers92

Would it be possible to use fiber optic cable instead?

Originally Posted by ih8cornnuts

I used to do this on the floorboards of my station-wago when I was 16. Bench seats in a car from 1987 meant NO cupholders Surprisingly the car was pretty free of stains but filled with sand and In'n'out burger wrappers. Lived in Socal growing up.

Originally Posted by michaeldamann

My Power Inverter.

And My Led's Inside... Working on White curtisy Lights on the bottom of the door so when you open they will come on...

I had rigged a 6 disk cd changer... But I got a new radio for my Birfday

Amp Killswitch.

I hate when People have Tiny subs in the cherokee... You need these Badboys.

Led's on my subs..

Anddd My 1000W amp on my Back Seat..

Idk why there not uploading........................... :'(

Originally Posted by ih8cornnuts

Please get those links working or at least provide a place where we can see them. Interesting in some of these!

Originally Posted by arorton

Most people get small subs when they're tired of the over kill... I'd gladly trade my two 15's for a ten or a twelve at this point..

Originally Posted by ih8cornnuts

I used to do this on the floorboards of my station-wago when I was 16. Bench seats in a car from 1987 meant NO cupholders Surprisingly the car was pretty free of stains but filled with sand and In'n'out burger wrappers. Lived in Socal growing up.

Originally Posted by ih8cornnuts

Thanks for the complements guys. It might take me a good week or so on the write-up so I'll just throw a quick small "write-up" here.

I basically spliced the wiring into the rear dome light, added a fuse and ran the wires through the rubber "wire-way" from the body to the hatch. I cut a strip out of the rear gate plastic trim (remove it first please) for the light to recess in. I did have to glue it to get it to stay because it is meant to be captive in a piece of 3/4" plywood. I used an aluminum recessed profile and lights made for furniture but you could easily use puck/spot lights to the same effect. I still would like to add a switch as it blasts the interior with light every time I open the doors.

Components I used came out of the Hafele catalog. Page 14 Here. I would recommend sourcing an led strip that works with automotive 12V and fits within this extrusion. So whatever you buy has to be less than 14mm or 9/16" wide.

Extrusion 13/16"W x 5/16"H x 98"L
PN: 833.72.762 MSRP $48.00

End Cap
PN: 833.72.768 MSRP $4.00

Originally Posted by mitchlikesbikes

i hate when people put two giant subs in anything. i bet your rattling hatch sounds awesome haha

Originally Posted by Basslicks

Well, thanks Mr. Nolte!



That's pretty spiffy! Awesome idea!