Hi, i got new controlarms, front and rear (since my rear was very rusty i got new for all). But i also did buy polyurethane bushings from energy suspension some time ago that i have in the garage, should i replace the bushings in the new controlarms, are polyurethane so much better that i should do it?

 

its a pain to replace them but in the long run it may be worth it... i had to burn my old ones out :P

 

ok, the installation say that the outer metal shell must remain in controlarm, so its only the rubber that i have to remove? Is it possible to push/press the rubber out or is the rubber molded in the metal shell?

 

well i know the stock ones are kinda like glued in but i bet you could press them out

 

I had mine replaced and the mechanic had to burn them out.

 

For what it's worth, you can replace the whole arm for cheaper sometimes.

 

i'll soon be replacing the whole arms after i've read how stubborn the bushings are to get out/in.

 

That's what I did. Are you lifted?

 

only about 2.5.

 

In a ZJ? You could probably replace them with WJ arms. Don't know that though.

 

which brand CAs did you buy? nappy's is expensive, i was thinking moog.

 

I wouldn't replace with other stock ones unless the price was right. I replaced mine with RC fixed ones I got online for $50.

 

i've got a bunch of my stuff from this guy:

Kolak@aol.com -- kolak performance. he's got some pretty fair prices. i think he's in AZ.

i haven't checked with him yet on the CAs.

 

Please note the WJ uses a 3 point rear mount.

 

I was talking about the front arms.