Would someone be kind enough to post or email a wiring diagram for a 2000 4.0l cam sensor? I need to know where each of the three wires connect and if it is a hall effect or VR sensor? Thanks for the help!!!!

 

Welcome to CF. My scanner's down so I can't scan that right now. But I can send you a pdf FSM for the WJ if you want it. I'll send you a Private Message.

 

That link has been shut down apparently. Sorry.

 

I don't have the diagram for a 4.0l but I do have it for a 2000 V8 4.7l. It should be the same. Basically wire 1 on the cam sensor connects to the cam sensor terminal on the PCM. Wire 2 connects to wire 2 on the crank position sensor. Wire 3 connects to wire 3 on the crank position sensor. Wire 3 from the crank position sensor goes to the PCM and is the 5 volt feed.

PM me or post an email address and I will send you the diagrams.

 

Thanks ET JEEP, my link for WJ pdf FSM's has apparently closed. I'm glad you stepped up to help out.
Dan

 

Glad to help. Diagrams sent this morning.

You, family and all members here have a Happy Thanksgiving.

Juan

 

Thanks Juan, and Happy Thanksgiving to you and yours as well.

 

Thank you, Juan and Dan, for the help. The diagram was just what I needed. I hope you and your families have a wonderful Thanksgiving!

 

hello, so im stuck on the same boat as the other person you helped out with the diagram, is there a way you can send it to me as well. thank you so much if you are willing to send me a diagram.