Its home made. I bought it as plan metal with just the face, added the hitch and tabs with some help form a few Buddies on here. Total cost $210

 

I forgot to add to the list....

60MM throttle body.
APN Exhaust manifold which I am going to heat wrap (for the 7120 head ports)

7120 exhaust ports are bigger and the 0331 manifold wont cover the holes.... UPGRADE!

 

great build dude i hope that mine can be that bad *** someday

 

Thanks! oh it will be. took me 4 years to get around to start building it.

 

Subscribing. Very interested to see how this turns out. Am considering doing this in the fall. Good luck.

 

Thanks! I may need it lol, I will be happy as long as Its reliable once its done.

 

What bumper is this?[/QUOTE]
it's custom.

 

Oh yes, Thanks for the help! let me know when you can track down that input!

 

will do! so far the two that were sent from colorado to me were the wrong ones too, so i'm doing great at getting the wrong ones LOL

 

Go figure... ****ty man. Sounds like you have my luck lol

 

Wow this is a amazingly well, thought out build. Had a question about your shackle relo set up. You are running a 4.5 re coil in the frt and raised your spring buckets to level it out? Cause I to am running a 4.5 re spring and wish not to go much higher but would like to do shackle relo. Did the relo increase it that much?

 

Thanks man!

yeah thats how I got to my 5.5" of lift. the rear lifted about 3/4"-1" So I would just throw some 3/4" spacers up front and It should be good to go.

My rear setup is HD shackle reliocation brackets(1") , 3.5" RE leafs, and RE lift shackle (1") , and added a .5" overload pack for when I am loaded with gear. 6" in the rear. 5.5" up front...

 

My current set up is similar re 4.5 coils w/ 3/4 spacer, re 3.5 leaf paks and HD shackle. sits 5.5 all four corners. I have seen a couple relo designs and one I plan on copying. Is your shackle angle around 45 degrees?

 

At ride hieght.


You could ditch the HD shackle to suck up 1 inch and still be at 5.5" with relocation brackets....

 

I have gotten some porting done today... need to finish it up and then polish it. I am not trying to go very big with the ports, just clean out imperfections from casting and smooth out transitions a bit. The ports are already bigger then my stock head by quite a bit!