Picture?

 

Could I use copper line to replace sections of fuel line or should I stick to steel?

 

I would say steel, as copper will work harden far quicker.

 

This caveman no do pics

Should have added 2000 XJ, if it matters

 

without looking..... maybe low gas light?




thats the same cluster i have. the ORANGE light at *8* o clock is the low fuel light. unless you have another light that is RED at SEVEN o clock, then I am stumped. :-p

if it is just a red led that u see there even when it isnt lit, might be aftermarket alarm light.

 

Copper is soft, probably won't end well if your tire picks up a piece of gravel

 

I was thinking one of these two

 

I heard that the little red light is the warning that the engine is in self-destruct mode.....

 

does anyone know, off-hand, what size socket I need to turn my crank over by hand? I have to attempt to replace my camshaft position synchronizer and sensor in a parking lot. :/ I'm just trying to minimize the amount of tools I need to bring with me.

Thanks.

 

You win, salad

 

19mm or 3/4"

 

Might be. There was a speaker horn under hood when he first got it. "Luckily" hasn't caused any stupid problems.
The light is only about 1/8" dia.
Low fuel light is yellow icon on gauge itsself.

Thanks

 

Now your drive shaft won't come off the yoke on the highway, catching a pot hole and flipping you into the school bus full of children on their feildtrip!
Nice job!

 

We're talking about me here. That's still a distinct possibility, but at least with the right bolts I won't end up cage-side down in a river

 

not from this anyway