That is a "Heater Control Valve." It diverts coolant flow when you're not using the heat.

Later models don't even have it. You can remove it and hook the hoses together...

 

Control valve for the heater, i couldn't give you a more specific name but that's essentially what it is.

EDIT: And i stole Andy's answer, 10 SECONDS LATE!!!!

 

My chilton book says i need to lift the rear of the vehicle to remove my rear sway bar. Is that actually necessary?

 

nope I ripped mine off without even taking the wheels off, although I wish I had lol

 

Im assuming itd be easier then? Im too lazy lol

 

I've had a popping coming from my front end for quite some time now. New front wheel joints, tie rod ends, adj. front trac bar. I've looked at it and can't seem to find it. It used to only doing when I was in 4wd crawling up hills it'd pop whenever I'd bounce around. Now I noticed it does it when I put it in reverse or am backing up and I stoop. It'll clank, any ideas?

 

Front driveshaft u-joints? Motor mounts? trans mount? shocks fullys tightened down?

 

I've looked at the ujoint but they look fine?? Idk on the mounts but I can feel it in the pedal sometimes. And I'm pretty sure the shocks are tightened down, I can check

 

Just to get the tires off. I lifted my jeep by the axle, took the tires off, stripped the bolts and just went after the ****er with a sawzall. Took a little persuading to get it out, but it was easy.

 

Holy hell ive been wrenching on the bolts holding the sway bar to the rear springs for 45 minutes. Not even a budge. I even lifted it up and took the tires off.

 

How do you stoop a jeep?

 

Saw zaw

 

Well unfortunately i dont have one. Its on the agenda list lol. Whrre would i cut it with a sawzall? Just at the bracket?

 

anyone in here alreaddy rebuilt a transmission ? im trieing do that falowing a excelent videos that a guy put in youtube but im stock whit the fifth gear shift rail ( the begining)cause it doesnt came out like the video , even i alreaddy had removed the screw of the fifth fork the rail should go along and out but it doesnt and im lousing my mind cause i look and relook and i dont see where that thing are stocked...

 

Sorry I'm not perfect at spelling every word correct 100% of the time, stop* is what I meant. Any ideas or did you just have to get that said?