GoinJeep

Engine light came on.
Went to Advance Auto Parts to have my Diagnostic Checked.
It came up: Code P1294, Idle Speed Malfunction.
Looked it up in my Haynes Manual.
The manual couldn't tell me a dag gum thing!!!

Can someone please point me in the right direction.

Thanks

VTJeep

Clear code. Does it reappear?... Maybe TPS?

GoinJeep

Idle has been a little high for a while now.
Don't know how to clear the code.
TPS?

BrofessorXJ

You could try cleaning your Idle Air Control. It's located on the throttle body.

Ryan Durty

So i have replaced my IAC, my TPS and my MAP. I cleaned my throttle body, and cleared the code. Code was gone for about 4 days. Unplugged and cleared it all over again, then everyday same issue of check engine light turning on and having to redo everything with the IAC. So i took the replaced IAC off to check it cause maybe it was a faulty part, and what do you know it sprung into pieces taking it off. So with the warranty i replaced it, and it started running fine again, but now 3 says later the same code pops back up... Any idea why? Faulty part again, have yet to check? Something else?

BruceB

You might want to closely inspect the wiring involved....may have a bare spot wore into it. You might even want to peel back the plastic protector insulation. Also make sure your connectors are clean and not cracked.

I am not an expert...just offering my thoughts...

good luck