dumb question
#2
CF Veteran
Join Date: Feb 2010
Location: Oroville, CA
Posts: 12,367
Likes: 0
Received 19 Likes
on
18 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0 with all of the noise and clatter
The bump stop limits the upward travel of the axle. You extend them after installing a lift to keep the suspension from binding.
#3
Member
Join Date: Sep 2010
Location: duncan b.c
Posts: 223
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L h/o
exactly^^^^^^^^^^^^^^ if u look at your front springs there is a tube with a rubber piece on the end (bumpstop)in the middle of the coil. when the suspension compresses this piece will eventually hit the axle . stopping travel upward .
#4
Senior Member
Join Date: Dec 2010
Location: Linthicum, Md
Posts: 903
Likes: 0
Received 1 Like
on
1 Post
Year: 1987
Model: Cherokee
Engine: 1987 4.0L (242 CID) I6 RENIX FI 242 173 hp (129 kW) @ 4600 rpm, 224 lb•ft (304 N-m) @ 4000RPM
dumb questions get dumb answers. no seriously when it comes to learning about your jeep, there are no dumb questions. unless you dont know where the gas goes...
with that in mind, did someone tell you or do you think you need extended bumpstops?
with that in mind, did someone tell you or do you think you need extended bumpstops?
Thread
Thread Starter
Forum
Replies
Last Post
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
thanser
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
3
09-15-2015 08:43 PM
mach3lude
Modified XJ Cherokee Tech
17
09-10-2015 02:34 PM
sikkev
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-05-2015 11:33 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)