Does anyone have any ideas? I reset the ecu and my car works fine but there are no signs of life in the kenwood head unit

 

Wait, i was wrong. My dash doesnt work either

 

Oh man, nobody's got anything?

 

How exactly did you do the reset? If nothing electrical on the entire dash works then obviously power isn't getting there but I am not sure if there is a fuse/relay or feed wire specifically for that so I will have to check today and may have an answer for you if no one else jumps in.

 

I did the positive to negative discharge way. First time i did it that way too. iso there was a fuse out for my gauges, so those work now. Everything except the radio. I checked the fuse on the back of it and all other fuses i think because dont have a manual

 

I have to ask you did have both terminals unhooked from the battery when u did it right lol

 

My first thought exactly Nathan.

 

I know that sounds more likely than anything i can think of, but no they were disconnectedi

 

I'm betting you blew a fuse. Is the radio getting 14.4V when the car is on? Both red and yellow wires need to have power. Aftermarket hus usually have a buss fuse on the yellow wire.

 

ok i finally had time, the yellow has over 12 volts and the red has nothing

 

The red is switched. It should turn on when your ignition is on.

 

You might of fried your flux capacitor. =P