Ok been pondering this a few days. From what I understand when you go to a 1 piece axle instead of a 2 piece axle shaft there isn’t really a spot for the seal on the passenger side. Rather than half @$$ dremelin in a spot, or sending it down the pumpkin tube with no place to bump up to, why can’t you send it down the outside axle shaft of the tube and have it bump up against the outside shaft seal? It would give it a stop plus would hold it in place not allowing it to shimmy so to speak and fail? Or better yet does anyone make an outside seal with the inside axle dimensions? Has anyone tried this?