97+ Header panel on 94 XJ?
#4
Herp Derp Jerp
Join Date: Nov 2011
Location: Parham, ON
Posts: 18,251
Likes: 0
Received 12 Likes
on
11 Posts
Year: 1999
Model: Cherokee
Engine: 4.0L OBD-II
Apparently changing fenders is also required to keep the body lines smooth. I think old style has an angled corner at the top whereas 97+ is rounded.
#7
CF Veteran
i used a 99 clip with fenders on my 90.
the 97+ uses two marker/signal lights under the headlights, where as my 90 (and your 94) only uses one. so i simply just put the one in. i clipped the other socket off the 99 harness and installed that into the other hole, just to seal it up.
then as for the side markers, i rednecked the 90 bulb/socket into the lens with some tape if i recall, as the older socket is slightly different. i have had no problems with the fit for the few years i've had it.
so yeah, it's as easy as it gets. but go for the newer, rounded fenders for a clean fit and finish.
the 97+ uses two marker/signal lights under the headlights, where as my 90 (and your 94) only uses one. so i simply just put the one in. i clipped the other socket off the 99 harness and installed that into the other hole, just to seal it up.
then as for the side markers, i rednecked the 90 bulb/socket into the lens with some tape if i recall, as the older socket is slightly different. i have had no problems with the fit for the few years i've had it.
so yeah, it's as easy as it gets. but go for the newer, rounded fenders for a clean fit and finish.
Trending Topics
#9
Member
Join Date: Jan 2013
Location: north jersey
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
The power block show trucks built a 2door with a 97+ clip on it forget what year it was just know it was the older body style looked good imo
Thread
Thread Starter
Forum
Replies
Last Post
Cane
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
23
12-11-2015 11:09 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)