Hey I'm not a torx bolt don't yell at me lol

You know damn well I meant what part of the Cherokee... I mean are you literally disassembling the whole thing?

 

Had a tire blow out (tore the bead) on a rain-slicked corner, did a 180 and nearly rolled it (but luckily it stayed upright). Then put the doughnut on and went to get a new tire, and underware change lol.

 

Yes whole thing. Doing floors, frame rails, inner and outer rockers, stiffies, dropping tank, shackle relocators, blah blah blah

Okay I guess I'm not touching the engine bay lol

 

Almost finished making my nut strips, just need to get the nuts and bolts. I would have finished them today but no one near me carries the size bolts I want. It shouldn't be hard to find M12x1.75 10.9 bolts and matching nuts, but the local Hardware store didn't have anything over an M8 and Canadian Tire stopped at M10, both only stock grade 8.8. Going to make a trip into Ottawa tomorrow morning and head to Ottawa Fastener Supply. I have been able to find every odd sized bolt I have ever needed there. They even had the metric studs and nuts I needed for my Dodge Stealth exhaust manifold.

 

Ah I see. I will treading down the floor pan path sooner than later. Probably this winter.

 

I guess this shows my XJ's place in my life...

 

Looks like a bandaid, work on cars much? Not being an ***, just saying, if not then get used to those.

 

Isn't that annoying? They don't even have SAE grade 8. Those stupid packs of screws are irritating.

Paint in the winter sucks lol

Gloves?

 

Is that a shadow or is his hand brusied?

 

Damn I didn't even think about that part. Hopefully by then I will he working in MY garage which I will have a heater (like a kerosene salamander) maybe I could use that to "bake it"

 

Installed a tranny cooler I got from the junkyard for 10 bucks out of an old Exploder. Bypassed the radiator, and did a full trans flush.



While I was at it, I relocated the horns so they don't hang down all stupid like before.



AW4 fluid looked like straight used motor oil.

 

Put this on

 

Gutted my axles and started putting together ring and pinions for 4.88 gears

 

Awesome

 

Do you have a temp gauge somewhere?


Or "ignite it".. Those kerosene forced air heaters will blow dust and debris into fresh paint. Infra-red propane heaters are great for garages.