What did you do to your Cherokee today?
CF Veteran
Joined: Sep 2010
Posts: 12,692
Likes: 6
From: Mercer County, NJ
Year: 2001
Model: Cherokee
Engine: 4.0L I6 HO
Junior Member
Joined: May 2008
Posts: 15,016
Likes: 11
From: +34° 25' 35.67", -81° 21' 12.04"
Year: 1993
Engine: 4.0
probably will wind up peeling it off. I have commitment issues so I used vinyl.
Senior Member
Joined: Apr 2012
Posts: 735
Likes: 0
From: Los Banos CA
Year: 2000
Model: Cherokee
Engine: 4.0
My exhaust fell of yesterday on my way home, 3 of the bolts that mount the cat to down pipe look like they been cut. ****ing thief's. Comanche sounds like crap under throttle with open down pipe. Woke up my neighbors though when I rolled into my neighborhood around 11:30
CF Veteran
Joined: Oct 2012
Posts: 2,314
Likes: 3
From: Canton, GA
Year: 1996
Model: Cherokee
Engine: 4.0
Not necessarily to my Cherokee.. but I had to find something somewhat productive to do.
Trying to un-plastidip the one Ecco I did...
Peeling it wasn't doing so hot, so...
I left for a minute and when I got back my mom was painting the stripper onto the wheel...
After a couple hours:
And a bit of scrubbing with a tooth-brush:
Now I'm cleaning up some stuff I picked up from the JY:
Not pictured: cupholder and airbox lid. All of them are going to be for sale when I'm done, too.
Trying to un-plastidip the one Ecco I did...
Peeling it wasn't doing so hot, so...
I left for a minute and when I got back my mom was painting the stripper onto the wheel...
After a couple hours:
And a bit of scrubbing with a tooth-brush:
Now I'm cleaning up some stuff I picked up from the JY:
Not pictured: cupholder and airbox lid. All of them are going to be for sale when I'm done, too.
CF Veteran
Joined: Oct 2012
Posts: 2,314
Likes: 3
From: Canton, GA
Year: 1996
Model: Cherokee
Engine: 4.0
Beach Bum
Joined: Jul 2011
Posts: 6,123
Likes: 22
From: Cape Hatteras, North Carolina
Year: 2000 WJ
Model: Grand Cherokee
Engine: 4.0
Installed my Tatton's driveshaft. It's still a slip yoke end, but with a double cardan built into it. It reduced my vibes by probably 75%. I still need to point my pinion up with some axle shims but I'm lazy and don't want to do that. Might have a shop do it, it couldn't be very much money.
Seems the slip yoke has a small amount of 'slop' side to side and was causing the issue. Tatton confirmed this.
And note the advertisement for this shaft "helps reduce driveline vibration". Well, I want to 'eliminate' it.
On Topic.. Drove 20 miles on the beach today.
Last edited by SteveMongr; Dec 12, 2013 at 03:16 PM. Reason: picture
CF Veteran
Joined: Oct 2013
Posts: 1,589
Likes: 2
From: Denver
Year: 99
Model: Cherokee
Engine: 4.0
Hm, crud! I don't like that review. I still have to take it to highway speeds, I've only gotten it to 55 or so.
