Drove her to an niners after game party

 

Finished this:


Waiting to start selling them... Need to talk to UPS first.

 

Installed gears and bearings in my Jeeps 8 1/4. Fixing a botched job from a local installer, 20 thousands to much pinion shim, far too much carrier bearing side load causing bearing failure in one year & 10k miles, destroyed threads on pinion shaft. after three attempts by DF to correctly install gears with each time i had to go back into the differential to correct careless mistakes. Way to go Desert Fab!

 

Installed gears and bearings in my Jeeps 8 1/4. Fixing a botched job from a local installer, 20 thousands to much pinion shim, far too much carrier bearing side load causing bearing failure in one year & 10k miles, destroyed threads on pinion shaft. after three attempts by DF to correctly install gears with each time i had to go back into the differential to correct careless mistakes. Way to go Desert Fab!

 

Finally installed the turn signal markers on my tj flares.......so sexy, can't wait to do the 97+ clip conversions with all clear markers maybe smoked a little but lets get the front clip first!!!

Ended up putting my Moab rims(stock rubican size) back on since I need the gas mileage right now. Also enjoying the extra bit of power since I'm used to 33's. DEFINITELY need my IRO double shear track bar now or I may just go buy the $40 TRE for the time being. It would up the resale of the track bar by $20 or so when I do upgrade.

 

the stickers?

 

Tire carrier.

 

Do you have a pic without a tire? I was wanting to point something out

 

Point

 

Id gusset the top

 

Ima recommend one thing. Add a piece from the top to the tire mount.

 

I though about doing that and It was still up in the air... I eventually will. <- Lol I'm Will. Anything else, ya'll like it?

 

Cap the top, an put another piece of steel on the other side of where the tire mount joins the vertical piece.

 

I wasn't going to cap either end because it's an open tube so it would just run through... I didn't see it as a big need. I will gusset the top though in the future

 

Well if you want to kinda mass produce them that would help with the looks. And maybe you can paint them with bedliner.