So the diagnostic scanner puller the code for this. Can someone tell me where this sensor is located? Is there an input sensor as well?
Schematic would help me tremendously.

 

Thanks for your post.
We’re here to help but you must understand that all Jeeps are not the same.
In order for us to give you more accurate advice and help, we must know the following, along with detailed information as to the symptoms/problems etc:
Year
Model
Engine
Transmission


Also, the code NUMBER is very helpful......

 

It's right there above the muffler, it senses the bearings and the smog valve. Input sensor would be on the seat and it watch out for the deadly methane gases emitting fro the seat.

 

Sensor or solenoid? The trans control solenoid is located inside the trans pan. I'm pretty sure the terms can be used interchangeably. One end of the solenoid is connected to the valve body, a middle part is mounted on the side of, and the third is plugged into a few different components towards the front of the pan.

 

If you are taking about your 2000 Grand Cherokee, you'll be better served if you post your question on a GC forum.

Cheers.

 

If we only knew..........

 

it doesn't really matter, I don't think. The 42RE is what it is, besides there are plenty of GC's on here

 

What matters is that the OP hasn't given any clarification and we're trying to figure this out based on little to no info......

 

Could be a 1991 XJ or a 2014 WK2

 

Or a Borgward Isabella.

 

I have always wanted one

 

this I agree with. But after scrounging the JY for all sorts of these parts around and near the TCS I'm pretty comfortable with them. But some info would be great

 

I am sorry. I meant to put that it is a 2000 grand cherokee Laredo 4wd.

So it is pinging the output sensor. Is it located almost to the driveshaft?

 

What exactly is the code?


We still can't help u any further without it either

 

The guys in the Grand Cherokee forum will be able to help you then: https://www.cherokeeforum.com/f5/