I hooked up the flush kit and ran water through the heater inlet hose where I put the new t-fitting. Came out nice and brown!

 

I don't guess I cleaned up the thermostat housing enough because coolant leaked through the new gasket so I cleaned them up and we're good to go.

 

Just discovered that my fan clutch is bad/going out. So tonight I'll be replacing that. Hopefully it will solve the overheating problems.

 

Old clutch vs. New clutch.... I now run below 210 for the most part, even with a/c on.

 

Ok I have to ask? What clutch did u go with? Looks like it will work a lot better...

 

I got the hayden clutch. It was the only replacement clutch available at the auto part store. It was like 40 bucks. There is a lot more airflow.

 

Thanks man. I'll look into that!

 

Yeah no problem.

 

Haven't updated in a while. Been busy with school and football. Found out this morning that my left rear brake drum is leaking. I'm assuming it's the cylinder, so I'll replace that tonight and post some pictures.

 

Was in a rush so I didn't take too many pictures.

 

Picture from a local mudding spot.

 

.

 

My track bar bushing was bad and the frame hole was slightly larger than the stock bolt so picked this track bar and frame mount and bolted it up.

 

wheel grabing round bends

 

Not quite sure what you are saying or asking