No sorry i put a gasket sealer on it also

 

Thanks man.

 

You shouldn't have to put anything other than a gasket on it. Just make sure you clean the two surfaces really good.

 

Thank you for the awesome picture, but where does the switch I want to install come into play? Can I just splice the chime and light wires to a switch? I have no electronics in my doors.

 

Oh ok sorry i missed that part lol the easiest thing to do would be to use a DPST switch. You would do just like the diagram i posted except replace the plugs with that switch so you can run two separate circuits on the same switch.

 

intiror lights will not turn off even if you push the on off switch. whats up with this? i got the bulbs pulled out right now so it dont kill the battery.

 

What about the other side? Light **** turned?

 

Alright, just pulled in the driveway...

Went to roll up the passenger window, it slipped and the went all the way down... did it just slip off the track? Or has something worn out?

When I hit the switch I can hear it cranking I tried to wiggle the window (what I could touch anyhow) while I hit it and got no where.

Its a 99 4dr power windows...

Anyone know what's the issue?

 

Sounds like it could have come off, I'd take the panel off and look inside

 

I will tomorrow, too late to get into it tonight.

The window that fell had beenoving slow for a while. Could that be a bad regulator? And would a failed regulator cause it to fall?

 

Yes

 

Thanks. That sucks tho.

Any one got a link to a write up with pics?

Oh, just to clarify yes on both parts?

 

Thanks for the help, I appreciate it.

 

It's brob been sticking and the sticking caused the teeth to strip.

 

Try this: >->http://www.lunghd.com/Tech_Articles/...ulator_Fix.htm