Naa, I'd try and get him down to $35. If he won't go lower I wouldn't buy it.

 

Well It's gonna be a parts front. He is givin me new hubs for both sides and calipers too. All for $50. Now I just gotta figure out how I'm gonna safely drop my front.

 

I'm going to the jy on friday on the hunt for an overhead console for my '00 xj. Where is the outside air temp sensor on the xjs equipped with overhead console??

I know I also need the wiring harnesses that goes to the fuse panel. Anything else I need??

 

okay so my jeep started to over heat again, when i bought it i had to put a new water pump and belt on and i wheeled it acouple of times and it would over heat, so i put a fail safe 160 thermostat in and it stayed right at 210 or below, i recently started it up and drove it around the yard and flexed it on a stump cuz it was such a nice day in awhile and when i back it off it over heated and was right around 250, so what do you think i should do, flush it maybe and see if its blocked?

 

[QUOTE=askingxforxit;1619436]I'm going to the jy on friday on the hunt for an overhead console for my '00 xj. Where is the outside air temp sensor on the xjs equipped with overhead console??

I know I also need the wiring harnesses that goes to the fuse panel. Anything else I need??[/QUOT

i pretty sure there mounted right behind the front bumper..

 

Isn't the fail safe stats unreliable...

 

Cool thanks!

 

My Jeep has a huge flat spot when you first accelerate. It is just off of idle. I know it is lacking fuel. I found a few vacum leaks and repaired them, I also changed the fuel filter, cleaned the throttle body, replaced the tps, and the crank shaft position sensor and it still has the same dead spot. Oh and I also checked fuel pressure and it was what factory specs called for. Has anyone experianced this and what should my next step be? Thank you for your help.

 

So I'm gonna try breakin down my stock DANA front end tomorrow. All I need is to find jack stands to reach the chassis. Any suggestions or tips? I have a 6" lift. Idk if I need my coil spring compressor or what special tools I might need. First time takin apart my front end. Thanks.

 

Can someone help me out on locating the bank 2 o2 sensor on my 00 4.0 Cherokee I've seen I couple pictures but I can't get a good enough view on the location
Thanks

 

I'm pretty sure its behind the cat.

 

I have a 1999 Cherokee Sport. I need to get a new interior door handle assembly for the front passenger side, any ideas where I can order that from?
thanks

 

Gonna put a Fishing Rod holder in the XJ.... might just do some bungee cords... anyone got a better idea? AND my XJ doesn't have any hooks in the rear end inside...this could get tricky... any solutions ot that problem?

 

Maybe get some rod holders made for your garage and modify them?

 

hi i have a 1993 cherokee and i have replace everything i can on my motor complete redone and i got in started and im getting smoke in the valve cover and there are ruber hoses that feed to the air box so the motor dieds after a few secound please help?