I was just referring to the circle clips...but I did just win two 760x u-joints in a jeep event raffle!

 

Ohhhhhhhhhhhh lmao

 

I figured out why my window wasn't rolling all the way up! My upper mounting bracket broke. The picture of my old one which is still intact.




So I thought that'd I'd just take the motor off the old track and and put my new motor on the old track. Well after I drilled out the rivets holding the motor on, the mounting plate came off, how is it attached? It doesn't looked welded or anything, and is there anyway I can fix it?

 

Ok thanks. The MOPAR is $5 more than the Echlin so I'll probably just get the MOPAR.

I have been on here for a couple years and while my post count is low I pretty much know who to listen to around here. Since I found a topic you don't have experience with do I get a prize. This has to be a first. LOL

 

Distributor gaskets can be had at Napa also. But, I just slip an o-ring on the dizzy instead.

 

So just find one the same diameter and call it good? Any RTV or anything needed?

 

LOL you haven't been paying close enough attention then; I only have about an eighth of a clue

 

Yep. NO RTV.

When build a 4.0 from scratch, the only place I use RTV is at the squared corners of the oil pan gasket.

 

^^^The only place you're supposed to use it.

 

96 jeep Cherokee no taillights changed fuse #7 taillights come on but no flashing changed electronic flasher then no taillights at all opened up the back left panel behind the spare tire and took out the left taillight and found the wires to the to for the towing lights wiring had been shredded by a rat or something I moved them around I got taillights yet again no flashing nothing just all lights worked and my Park lights but nothing happens to my break lights when I press the breaks and my lights work in my instrument panel and my Inside lights as well. Except for my turn signal instrument lights in the panel the ones that tell you that you which light is flashing they don't work and I spliced the frayed wires together correctly and then nothing but Park lights and are in constantly.

 

No rtv? So when I'm building my remmanned 4.0 the only place to use it is the square corners of the oil pan gasket?
Iv always put a tad on the gaskets for thermostat and water pump to get it to stick

 

Does anyone know the size of the bleeder valve on the front calipers of a 95 XJ, is it 3/8'th ?

 

Yes 3/8 and 5/16 in rear

 

Thanks!

 

How difficult is the transmission mount to replace!? Can't find any write ups on here about doing so