Popping/clunking from front suspension
#1
Junior Member
Thread Starter
Join Date: Jul 2015
Location: British Columbia, Canada
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Cherokee
Engine: 4.0L l6 HO
Popping/clunking from front suspension
Alright ive done many searches on what it could be but i cant find a definitive answer. From somewhere in my front drivers side there is a popping or clunking when i turn or go over bumps. I have found that out on a rocky trail with a decent incline at low speeds it happens much more (without turning or anything). Its almost like the weight of the jeep is being released and then slammed down on whatever the problem is. i need new ball joints as they have some upward play but would they cause these noises? thanks.
#3
Seasoned Member
Join Date: Jul 2015
Location: York County, PA
Posts: 264
Likes: 0
Received 1 Like
on
1 Post
Year: 1998
Model: Cherokee
Engine: 4.0
Not sure if you found the problem, but I had a similar issue that I just fixed. My sway bar link bushings were shot. Any time I turned or went over a bump, it would make a popping noise. Have a buddy rock the body of your Jeep back and forth while you inspect underneath.
#4
My swaybar mount bushings were bad, caused a clunk in the front end. You should also check your front axleshaft joints since it's occurring when you turn.
If a ball joint is bad, then it's probably time to replace all of them and possibly the tie rod ends as well.
If a ball joint is bad, then it's probably time to replace all of them and possibly the tie rod ends as well.
Thread
Thread Starter
Forum
Replies
Last Post
ElMartillo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
81
08-21-2016 05:37 AM
Wild Bill 53
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
04-09-2016 03:48 PM
mark4077
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
04-07-2016 06:04 PM
BigC9164
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
04-07-2016 12:01 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)