i need to know where the bolts that hold the wires/trans lines go.
a pic would be best but any help is grateful.

 

I had this problem a while back as I couldn't remember exactly where they went either. I just put them somewhere close to the middle of the pan and the lines. I don't think that it matter "too" much as long as they are supported and held firm.

 

Hope this helps. From a REnix, but probably pretty close. Pretty high-tech, eh?

 

thx cruiser, i think that hi tec piece of paper is what i needed. lol
i have been down that road with wire diagrams.

 

Someone with much greater computer experience should fix it up for us, don't ya think?

BTW, have you determined if the pattern is the same on your late model oil pan?