motor flooding out

Reply Subscribe

Thread Tools

Search this Thread

Apr 26, 2013 | 08:08 AM

#16

monstercherokee

Thread Starter

Seasoned Member

Joined: Sep 2011

Posts: 474

Likes: 0

From: segoville tx

Year: 1997

Model: Cherokee

Engine: 4.0 6 cylinder

Quote:

Originally Posted by cruiser54

Vacuum to it?

Ever check your sensor ground circuit?

Were is that located

Apr 26, 2013 | 08:56 AM

#17

cruiser54

::CF Moderator::

Joined: Aug 2011

Posts: 43,971

Likes: 1,578

From: Prescott, Az

Year: 1990

Model: Cherokee (XJ)

Engine: 4.0

Quote:

Originally Posted by monstercherokee

Were is that located

Cruiser’s Renix Sensor Ground Test
　

This sensor ground circuit affects the CTS, TPS, IAT, MAP, ECU and diagnostic connector grounds. It’s very important and not something to overlook in diagnosing your Renix Jeep as it is common for the harnesses to have poor crimps causing poor grounds. If any or all of the sensors do not have a good ground, the signal the ECU receives from these sensors is inaccurate.

Set your meter to measure Ohms. Be sure the key is in the OFF position. Using the positive (red) lead of your ohmmeter, probe the B terminal of the flat 3 wire connector of the TPS . The letters are embossed on the connector itself.

Touch the black lead of your meter to the negative battery post. Wiggle the wiring harness where it runs parallel to the valve cover and also near the MAP sensor mounted on the firewall. If you have an 87 or 88 with the C101 connector mounted on the firewall above the brake booster, wiggle it, too.

You want to see as close to 0 ohms of resistance as possible. And when wiggling the harnesses/connectors the resistance value should stay low. If there is a variance in the values when wiggling the wires, you have a poor crimp/connection in the wiring harness or a poor ground at the engine dipstick tube stud. On 87 and 88 models, you could have a poor connection at the C101 connector as well.

Revised 06/12/2012