I want to mount 2 FLOOD light type lights on the front and rear 1989 CHEROKEE , ROOF RACK BARS ... I want two lights (rectangular) in the front bar, and then 2 (REGTANGULAR) lights mounted on my rear roof rack bar..

BUTTT HOW AND WHERE DO I WIRE THE LIGHTS IF MY LIGHTS ARE DRILLED AND BOLTED ONTO MY ROOF RACK?? I AM NOT LOOKING TO CUT HOLES INTO MY ROOFTOP TO WIRE THE HARNESSES AND SWITCHES.. BUT I WANT IT TO LOOK CLEAN AND VERY EXTREME..


IFF ANYONE GOT ANY IDEAS OF WHERE I COULD MOUNT THESE LIGHTS AND WIRE SWITCHES AND HARNESSES TO MAKE THIS EXTREME... IFF YOU WANNA SEE THE JEEP

LOOK AT MY PISC OF MY BLACK 2 DOOR CHEROKEE !!!!!!!!:t humbsup:

 

Stop yelling you're giving me a headache

 

But seriously, you don't have to drill holes, just run the wires through the grommet that the speaker wires run through to the back hatch and then up to the roof. The gap between the hatch and the roof should be more than big enough. just be sure to electrical tape the wires

 

check this out it show's some ways to do it https://www.cherokeeforum.com/showth...ht=roof+lights

 

Post #3 in the thread is what I was trying to describe. Good link.

 

no problem i just used the search