4X4XJ

Ok another stupid question...

I bought a "Bugflector" for my 01 XJ and for the life of me I cannot figure out how to install it. It came with 2-sided tape attached to the lip but if I attach the Bugflector so that the flange goes around the hood (like it appears to fit) then the tape is sticking out and not touching anything to secure to...

Has anyone installed one of these? How the %*$! does it attach? My XJ is driving me insane today...

Thanks guys!

4X4XJ

anybody out there?

OOdynamite

Pics would help

MVDCXJ

From looking at this picture it doesnt look like its supposed to go around the hood all but rather attach to the header panel that encompasses the grille and headlights. See?

4X4XJ

very helpful picture, thanks!

closer9

Can't remember which one we have, but that pic shows how ours is mounted. There is a cutout in the middle of the deflector for the JEEP on the header panel. I will also say we got around 500 miles out of the double sided foam tape. I had to peel all the foam tape off, and installed the clear gummy 3M double sided tape. I have used it for several things, and you will usually break something before it lets go.

jeepgrlxj

The installation instructions
http://www.lundinternational.com/fil...ctors/BF76.pdf

MVDCXJ

Not really. That shows the installation to be on the hood, like it should be for any vehicle whos hood comes all the way to the nose of the car. Out XJ's hood stops short so the bugflector doesnt mount like that