where is that fan switch write up? is ther a website? or did ya say u'd make one? i 4get!

p.s. lovin ur jeep by the way!!!!!

 

I still havent done it i will try and find you the write up i looked at though

 

hey thanks a lot!

 

just found this one its pretty good
http://naxja.org/forum/showthread.ph...ght=fan+switch


this is actually better than the one i looked at before so i think i will use this way

 

thanks much! keep up the good work on the jeep!

 

is it tomorrow yet cause i still haven't took pics

 

haha i do have pics of the painted wheels, along with some more wheeling pics

 

daymn found this wayyyy back on the 12th page

i guess its time for an update

been working on a cowl snorkel mod

got this from menards $2.00


kids please clean up after your self's


bend in to a weird shape


make sure it fits kinda sorta good




this is were you run the tube


if you have a hole saw great use that

if your ghetto do it my way







seal up this hole in your air box


and where your new intake tube sits you will need to cut a hole and seal it off nicely, i didnt take that pic

it will look something like this


but i didnt take pics of it finished, there are deffently cleaner ways to do this to make it look factory or something but not for 2 bucks

you will get a little hissing noise after this is done, the way i fixed it was turning that little **** on the radio

 

Does the hood smash it down any? Looks like a good idea. I'd like to see a couple finished shots.

 

well i gots me the hillbilly hood scoop (hood spacers) so its not touching at all but i suppose it would touch a bit if you didn't have the spacers i have seen some people smack the braces down a little bit so it fits but how do feel about hitting the under side of the hood with a hammer

 

Sweet

 

I had a buddy grab a gastank skid from the junk yard while he was there pre 97 though they charged him 5 bucks i gave him a 10 cause he brought it to me
gota modify it to work



in this pic you see were it bends up

you gota bend that almost straight
but first and a crappy pic you got to break this weld and bend thises little ears out straight


for another way to do this check this wright up
https://www.cherokeeforum.com/f2/pre...st-96-a-22399/

i have it on and done but no pics i will get some eventually

 

nice look rig man..i need to put the wrench down and pick up some sandpaper..the od green looks great

 

Its looking Very nice. Wish i had the money to put into upgrades hahahaha. My money has just been going into parts that are going/gone.

 

got the skid plate on all but 2 bolts that i must have droped and lost taking the hitch off, then i got 2 new bolt but lack of free time and motivation has stoped me from putting them on i will get some pics when i do it

also picked up a highlift jack from a member on NAXJA, i sold him some ford ranger wheels a while ago and he gave me the jack in trade for some center caps for the wheels so it cost me about 29 bucks he said he only used it about 3 times, while i was there he noticed a front diff skid that he didnt want any more cause he was getting a whole cover picked that up for 10 bucks its a rustys model kinda like this http://rustysoffroad.com/mm5/merchan...egory_Code=DIF but must be the older model, i thought they were both good deals

got a short list of work to do all maintenance

Oil change
Tire rotation
Front and Rear pinion seals
Change Axel fluid
Trans filter and fluid change
Rear brakes are original at 165k
Front brakes are getting there
Repaint my front bumper its staring to rust