rear leaf spring recommendations for slight lift
looking at replacing rear leaf springs on my 97XJ Sport. i've been looking at dorman's but am open to suggestions. i'd love to get an 1"-1.5" lift after settling if possible. anyone have any suggestions/recommendations with links? thanks
I just ordered the Rancho RS44148 leaf springs. Very little out there about them but all info is positive. They are rated for 1.5". Mine are being installed today so I should know more later.
Senior Member
Joined: Mar 2014
Posts: 539
Likes: 4
From: Cincinnati, Ohio
Year: 1999
Model: Cherokee
Engine: 4.0
Senior Member
Joined: Mar 2014
Posts: 539
Likes: 4
From: Cincinnati, Ohio
Year: 1999
Model: Cherokee
Engine: 4.0
Thanks guys!
Those are 30x9.5x15.
If I could do it all over I would have went with 10.5 instead of 9.5.
I have the JKS ACOS system on the front. Will probably end up leveling it off when I get the time.
Those are 30x9.5x15.
If I could do it all over I would have went with 10.5 instead of 9.5.
I have the JKS ACOS system on the front. Will probably end up leveling it off when I get the time.
Trending Topics
looks great! do you happen to have a link to the dorman set that you purchased?
Senior Member
Joined: Mar 2014
Posts: 539
Likes: 4
From: Cincinnati, Ohio
Year: 1999
Model: Cherokee
Engine: 4.0
The Doorman right here.
I also used the stock shackle and bolt from that page.
http://www.rockauto.com/en/catalog/j...le.com+URL+%2F
I also used the stock shackle and bolt from that page.
http://www.rockauto.com/en/catalog/j...le.com+URL+%2F
The Doorman right here.
I also used the stock shackle and bolt from that page.
http://www.rockauto.com/en/catalog/j...le.com+URL+%2F
I also used the stock shackle and bolt from that page.
http://www.rockauto.com/en/catalog/j...le.com+URL+%2F
These can be gotten at Rock Auto but more info plus reviews here:
https://www.amazon.com/gp/product/B0...cm_cr_asin_lnk
As far as shocks I plan on using BPE's (bar pin eliminators)on my existing ones.
http://www.rocky-road.com/xjbarpin.html
https://www.amazon.com/gp/product/B0...cm_cr_asin_lnk
As far as shocks I plan on using BPE's (bar pin eliminators)on my existing ones.
http://www.rocky-road.com/xjbarpin.html
Last edited by EZEARL; Oct 13, 2016 at 02:30 PM.


