Okay Y'all. I'm wondering if there's any way to cut the lip off the back fender...
See the front can be cut to be flush along the body. I hate the lip on the back fenders. if anyone has done this or have tried doing lemme know
Michael.

I couldn't find a good picture so I borrowed this from XJ^REMY

 

Not without a lot, and I mean A LOT of extra work. Check out the numerous trimming write ups on here and you will understand.

 

Cut slits in it and fold it in.

 

Make cuts in it, and hammer it up. If you want more cut than that, you'll have to do a lot of work. Cut and fold is all I did to mine, and its plenty to fit 33's on 1.5" of lift.
Here's a pic of mine, cut and fold on the fenders, 1.5" lift, and 33's fit perfectly fine.

 

Compcut

 

Sorry i forgot to add. Ive allready trimmed them. I just wanna make the back fenders flush with the body and get rid of the lip. There 2 layers on metal on it. I have a hole on one side where you can see thru the body

 

There's no easy way to make It so there's not a gap between the body and inner fender

Only way to do that is to cut the lip off and weld on a new inner fender because the lip is outer body and the wheel well meeting together with a pinch weld.