Question About Control Arm Shims on 3" Lift
Member
Joined: Mar 2013
Posts: 123
Likes: 1
From: Georgetown, KY
Year: 1999
Model: Cherokee
Engine: 4.0L
Tell me about it! I took my wife's Yukon to the dealer to get aligned. I took off work early and sat in the waiting room 3 HOURS. The dude walked in at 5:00 as he was leaving and handed me the keys and said "your all good man". I told him I wanted the results print out, which he got for me and left. I got in the truck and looked it over......ALL he did was set the toe - camber and caster was out and the same specs before and after. To say I was pissed is an understatement.
I went by the next day at lunch and showed the service manager the print outs and asked him what he thought about them. He got me in after work and had another guy do it, who did it right.
...
I went by the next day at lunch and showed the service manager the print outs and asked him what he thought about them. He got me in after work and had another guy do it, who did it right.
...
Seasoned Member
Joined: Sep 2012
Posts: 268
Likes: 0
From: Barrie, ON, CAN
Year: 99
Model: Cherokee
Engine: 4.0L
If you plan on getting an alignment then just let the alignment shop do it, setting the castor is a main part of the alignment. And when you raise or lower you jeep its always going to change the toe-in. Unless you plan on doing an at home alignment, take you jeep to an alignment shop and never worry about it again.
And i had no bumpsteer whatsoever at 3".
And i had no bumpsteer whatsoever at 3".
Senior Member
Joined: Nov 2012
Posts: 999
Likes: 0
From: Tx
Year: 2001
Model: Cherokee
Engine: I-6
Seasoned Member
Joined: Sep 2012
Posts: 268
Likes: 0
From: Barrie, ON, CAN
Year: 99
Model: Cherokee
Engine: 4.0L
Thread
Thread Starter
Forum
Replies
Last Post
ROCKRIDGE 4WD
Vendor Showcase
0
Aug 28, 2015 12:28 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)