Modified XJ Cherokee Tech XJ (84-01)
All modified tech questions. If it modifies your XJ beyond stock parts ask it here.
Sponsored by:
Sponsored by:

need some advice and sugestions

Thread Tools
 
Search this Thread
 
Old Dec 22, 2014 | 01:49 PM
  #1  
mathew220's Avatar
Thread Starter
Newbie
 
Joined: Nov 2014
Posts: 13
Likes: 0
Model: Cherokee
Default need some advice and sugestions

Hello. i have posted on here before with great results. i want to say thank you for all the help. but unfortunately i am back again asking for help. i recently installed a 3in rough country lift on to my 2000 jeep cherokee 4x4. all was well for a few days, then i started hearing a clicking noise, like metal on metal, coming from what sounds like the drive shaft. i, so far have changed the u joints, and done a t-case drop. still have the noise. my trans mount is bad, and should be getting the new one in in a few days. only problem is that i doubt that is the problem. and other suggestion would be greatly appreciated.
Reply
Old Dec 22, 2014 | 02:33 PM
  #2  
Hopkins's Avatar
Junior Member
 
Joined: Sep 2014
Posts: 72
Likes: 0
From: Virginia Beach, VA
Year: 1998
Model: Cherokee
Engine: 4.0L
Default

Try to get a video of the noise happening if you can. It will make it a lot easier to troubleshoot. Otherwise your gonna have a million different suggestions to look into.
Reply
Old Dec 22, 2014 | 02:40 PM
  #3  
kcdt58's Avatar
Seasoned Member
 
Joined: Jun 2013
Posts: 417
Likes: 1
From: Hickory, NC
Year: 2000
Model: Cherokee(XJ)
Engine: 4.0 L
Default

Can you pinpoint the general location of the noise? Front, middle or rear of the Jeep? That would be a start.
Reply
Old Dec 22, 2014 | 10:02 PM
  #4  
burg3rlicious's Avatar
Seasoned Member
 
Joined: Aug 2013
Posts: 405
Likes: 0
From: Connecticut
Year: 1998
Model: Cherokee
Engine: I6 4.0
Default

Did you change out the trackbar and or control arms on the lift?
Reply
Old Dec 23, 2014 | 01:12 PM
  #5  
mathew220's Avatar
Thread Starter
Newbie
 
Joined: Nov 2014
Posts: 13
Likes: 0
Model: Cherokee
Default

I am unable to hear it when I take a video. It sounds like it is coming from the center of the vehicle right by the drive shaft. I have not changed the control arm or links, but I have put new bushings on to them.
Reply
Old Dec 23, 2014 | 04:23 PM
  #6  
98XJ1C4's Avatar
Junior Member
 
Joined: Oct 2014
Posts: 42
Likes: 0
Model: Cherokee
Default

Might need an sye. . . I had similar noises and it cured them
Reply
Old Dec 23, 2014 | 05:02 PM
  #7  
mathew220's Avatar
Thread Starter
Newbie
 
Joined: Nov 2014
Posts: 13
Likes: 0
Model: Cherokee
Default

thats what i was really hoping against. no mulla for one any time soon.
Reply
Old Dec 24, 2014 | 01:27 PM
  #8  
Fred/N0AZZ's Avatar
CF Veteran
 
Joined: Jul 2013
Posts: 7,554
Likes: 17
From: Monett, MO.
Year: 1999
Model: Cherokee
Engine: 4.0
Default

"Usually" with a 3" lift an SYE isn't required and I see you did a T/C Drop kit, that should have you covered on that part. Change out the mounts and see if that takes care of the problem.
Reply
Old Dec 24, 2014 | 09:23 PM
  #9  
mathew220's Avatar
Thread Starter
Newbie
 
Joined: Nov 2014
Posts: 13
Likes: 0
Model: Cherokee
Default

well due to the holidays, i wont be getting my mounts until next year ha ha, sometime early jan. i will try that once i get it. Also, Happy holidays and Merry Christmas!
Reply
Old Dec 26, 2014 | 03:48 AM
  #10  
andrewmp6's Avatar
CF Veteran
 
Joined: Jun 2011
Posts: 8,014
Likes: 17
From: Louisville,KY
Model: Cherokee
Default

If the trans mount and motor mounts are bad the exhaust could be rubbing on something it shouldn't be.Crawl under the jeep and look everywhere for clean spots.
Reply
Old Dec 26, 2014 | 10:28 AM
  #11  
Little Red XJ's Avatar
Member
 
Joined: Jun 2013
Posts: 117
Likes: 0
Model: Cherokee
Engine: 4.0
Default

Do you have the means to put the rear axle up on jack stands, put it in gear, and you or someone else slide under it to isolate the noise?
Reply
Old Dec 26, 2014 | 06:14 PM
  #12  
Puddlejumper97's Avatar
Member
 
Joined: Jun 2014
Posts: 117
Likes: 1
Year: 1997
Model: Cherokee
Default

Turn the radio up and it will go away

But mysterious metal noise on my jeep turned out to be loose lugnuts....can't hurt to check.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jpmarine6786
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
43
Oct 22, 2023 04:16 AM
Cherospeed99
Modified XJ Cherokee Tech
16
Aug 30, 2018 01:40 PM
sjm79902
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
Sep 30, 2015 11:14 PM
1991Jeep_Man
Cherokee Chat
12
Sep 29, 2015 12:54 PM
HS00XJ
Cherokee Chat
0
Sep 27, 2015 08:54 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -5. The time now is 06:05 PM.