messed up track bar ?
#1
Newbie
Thread Starter
Join Date: Jul 2011
Location: EMORY, TEXAS
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0l
messed up track bar ?
I just got my 3inch zone lift done on the front and was looking at the lower track bars and one of them has shims with adjusting bolts. {passenger side} and the driver side has none. The right side is all the way to the front and the driver side is all the way to the back, is that normal? I also noticed that my upper control arm bushings that are on the axle are shot ! i think thats where my clunking noise is coming from. I just dont know about them lower bars, thanks
#3
Seasoned Member
Join Date: Jun 2011
Location: Pensacola Fl.
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Engine: 4.0
He Means control arms. Replace the Bushings you dont really know if you need the Spacers until you have it aligned by a Pro, Make sure to request that they perform a "Caster& Camber Sweep" Before they just Set Your Toe& Let Ya Go! GL
#5
Newbie
Thread Starter
Join Date: Jul 2011
Location: EMORY, TEXAS
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0l
yea lower control arms not track bar my bad, doing to much at one time...i would of thought that they would have been the same but i guess not all that those bars do is center the axle under the frame right ? and the whole in the frame has about a 1 inch slot, 3 inch lift i would only need to more it forward maybe half way i would think
Thread
Thread Starter
Forum
Replies
Last Post
southfloridajeeps
Modified XJ Cherokee Tech
32
03-04-2023 01:10 PM
Jooman07
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-21-2015 12:13 PM
Sandyman
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
09-19-2015 07:55 PM
Rich164
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
09-08-2015 08:32 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)