Can any one tell me if I installed them correctly??
Cause I didn't understand how to set the length to 15 degrees

Is this correct?

 

If there wrong then mine are also.

 

 

Looks right to me. Put an angle finder on the side of the sway bar on the line between the eye where the disco connects and the bar turns inboard to confirm angle.

 

Thanks man

 

How do you plan on securing the disconnect when not in use? Looking for ideas....thanks

 

These came with my lift. http://dpgoffroad.com/products/dpg-s...-disco-cables/

They might give you some DIY ideas.

 

If you have a front skid plate you can use that. Or Zip ties

 

I did this about 15 bucks at ace.

 

I did this about 15 bucks at ace. Not sure why the pic didn't load the first time.

 

I dig it! Thanks

 

What's the use for the JKS sway bar ??????
Can some one tell me in specific??

 

It's not the sway bar, lots of us are using the JKS Sway Bar Disconnects. You run the stock sway bar. When disconnected, it allows your front axle to articulate much more than when your swsy bar is connected.

 

I had these on my 88 xj. And at turn full tuck I popped a hole on each side of. The inner fender well. Where I had them connected. Got mad and took the whole bar out. But I like the way you have them might try them again.