help please..
07-23-2014, 11:12 PM
#2
Junior Member
Join Date: Dec 2010
Location: SOMERTON ARIZONA
Posts: 84
Likes: 0
Received 3 Likes
on
3 Posts
Year: 2000
Model: Cherokee
Engine: 4.0
If it bounces from just the bolt that holds the trac bar in place then you can just tighten it and check your bracket as well and at the bottom if the trac bar if the heim joint moves around your going to need the heim joint section from the trac bar
07-24-2014, 08:16 AM
#5
Junior Member
Heim joints are cheap.
Pull it off, measure the diameter and length of the shaft and the diameter of the bolt hole. Then call Ruff Stuff.
It's most likely a 7/8" x 3/4".
Just measure it to be sure.
http://www.ruffstuffspecialties.com/...t_Code=78x34RE
Pull it off, measure the diameter and length of the shaft and the diameter of the bolt hole. Then call Ruff Stuff.
It's most likely a 7/8" x 3/4".
Just measure it to be sure.
http://www.ruffstuffspecialties.com/...t_Code=78x34RE
Thread
Thread Starter
Forum
Replies
Last Post
ddskush
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
1
04-08-2015 02:17 AM
stevesxm
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
6
10-21-2014 12:17 PM
Wayne,Az
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
09-18-2014 05:59 PM
Zack92MJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
55
10-07-2011 08:45 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
